From mboxrd@z Thu Jan 1 00:00:00 1970 From: hotran@apm.com (Hoan Tran) Date: Tue, 14 Mar 2017 11:06:51 -0700 Subject: [PATCH 1/2] Documentation: perf: xgene: Add support for SoC PMU of next generation of X-Gene In-Reply-To: <1489514812-19671-1-git-send-email-hotran@apm.com> References: <1489514812-19671-1-git-send-email-hotran@apm.com> Message-ID: <1489514812-19671-2-git-send-email-hotran@apm.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch adds support for SoC-wide (AKA uncore) Performance Monitoring Unit in the next generation of X-Gene SoC. Signed-off-by: Hoan Tran --- Documentation/perf/xgene-pmu.txt | 17 +++++++++++------ 1 file changed, 11 insertions(+), 6 deletions(-) diff --git a/Documentation/perf/xgene-pmu.txt b/Documentation/perf/xgene-pmu.txt index d7cff44..51f8179 100644 --- a/Documentation/perf/xgene-pmu.txt +++ b/Documentation/perf/xgene-pmu.txt @@ -23,12 +23,17 @@ equivalent of "l3c0/config=0x0b/". Most of the SoC PMU has a specific list of agent ID used for monitoring performance of a specific datapath. For example, agents of a L3 cache can be a specific CPU or an I/O bridge. Each PMU has a set of 2 registers capable of -masking the agents from which the request come from. If the bit with -the bit number corresponding to the agent is set, the event is counted only if -it is caused by a request from that agent. Each agent ID bit is inversely mapped -to a corresponding bit in "config1" field. By default, the event will be -counted for all agent requests (config1 = 0x0). For all the supported agents of -each PMU, please refer to APM X-Gene User Manual. +masking the agents from which the request come from. If an agent is enabled, +the event is counted only if it is caused by a request from that agent. + - With SoC PMU version 1 and 2, each agent ID has an enable bit which is +inversely mapped to a corresponding bit in "config1" field. The value by +default of config1 is 0. + - With Soc PMU version 3, agent ID enable mask is encoded and mapped into +"config1" field without inversion. The value by default of "config1" is +defined corresponding to each SoC PMU type. +By default, the event will be counted for all agent requests. For all the +supported agents of each PMU and agent configuration, please refer to +APM X-Gene User Manual. Each perf driver also provides a "cpumask" sysfs attribute, which contains a single CPU ID of the processor which will be used to handle all the PMU events. -- 1.9.1