From mboxrd@z Thu Jan 1 00:00:00 1970 From: thomas.petazzoni@free-electrons.com (Thomas Petazzoni) Date: Fri, 14 Apr 2017 22:53:12 +0200 Subject: [PATCH] i2c: designware: do not show SDA hold time warning when not needed Message-ID: <1492203192-28025-1-git-send-email-thomas.petazzoni@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org When the I2C controller IP block has a revision too old to be able to configure the SDA hold time, the driver currently displays a warning. However, it does so unconditionally, even if no SDA hold time has been configured through the Device Tree. This causes useless warnings when running the system, so only show the warning if a SDA hold time was specified. Signed-off-by: Thomas Petazzoni --- drivers/i2c/busses/i2c-designware-core.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/i2c/busses/i2c-designware-core.c b/drivers/i2c/busses/i2c-designware-core.c index 7a3faa5..7f9da6e 100644 --- a/drivers/i2c/busses/i2c-designware-core.c +++ b/drivers/i2c/busses/i2c-designware-core.c @@ -436,8 +436,9 @@ int i2c_dw_init(struct dw_i2c_dev *dev) dev->sda_hold_time |= 1 << DW_IC_SDA_HOLD_RX_SHIFT; dw_writel(dev, dev->sda_hold_time, DW_IC_SDA_HOLD); } else { - dev_warn(dev->dev, - "Hardware too old to adjust SDA hold time.\n"); + if (dev->sda_hold_time) + dev_warn(dev->dev, + "Hardware too old to adjust SDA hold time.\n"); } /* Configure Tx/Rx FIFO threshold levels */ -- 2.7.4