[PATCH v2 1/4] dt-bindings: Add support for samsung s6e63j0x03 panel binding

Hoegeun Kwon
2017-06-15T10:03:27Z

The Samsung s6e63j0x03 is a 1.63" 320x320 AMOLED panel connected using
MIPI-DSI interfaces.

Signed-off-by: Hoegeun Kwon <hoegeun.kwon@samsung.com>
Reviewed-by: Andrzej Hajda <a.hajda@samsung.com>
Acked-by: Rob Herring <robh@kernel.org>
---
.../bindings/display/panel/samsung,s6e63j0x03.txt | 24 ++++++++++++++++++++++
1 file changed, 24 insertions(+)
create mode 100644 Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt

diff --git a/Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt b/Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt
new file mode 100644
index 0000000..3f1a839
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt
@@ -0,0 +1,24 @@
+Samsung S6E63J0X03 1.63" 320x320 AMOLED panel (interface: MIPI-DSI command mode)
+
+Required properties:
+ - compatible: "samsung,s6e63j0x03"
+ - reg: the virtual channel number of a DSI peripheral
+ - vdd3-supply: I/O voltage supply
+ - vci-supply: voltage supply for analog circuits
+ - reset-gpios: a GPIO spec for the reset pin (active low)
+ - te-gpios: a GPIO spec for the tearing effect synchronization signal
+ gpio pin (active high)
+
+Example:
+&dsi {
+ ...
+
+ panel at 0 {
+ compatible = "samsung,s6e63j0x03";
+ reg = <0>;
+ vdd3-supply = <&ldo16_reg>;
+ vci-supply = <&ldo20_reg>;
+ reset-gpios = <&gpe0 1 GPIO_ACTIVE_LOW>;
+ te-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
+ };
+};
--
1.9.1