From mboxrd@z Thu Jan 1 00:00:00 1970 From: marco.franchi@nxp.com (Marco Franchi) Date: Wed, 12 Jul 2017 10:18:20 -0300 Subject: [PATCH 2/2] ARM: dts: imx7d-sdb: Pass 'enable-gpios' and 'power-supply' In-Reply-To: <1499865500-8857-1-git-send-email-marco.franchi@nxp.com> References: <1499865500-8857-1-git-send-email-marco.franchi@nxp.com> Message-ID: <1499865500-8857-2-git-send-email-marco.franchi@nxp.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Currently the LCD is turned on thanks to the bootloader initialization. In order to make the kernel to turn on the LCD on is own, pass the 'enable-gpios' and 'power-supply' properties. Also, the GPIO1_IO01 is not used as PWM functionality on this board. It is connected to the PWREN pin of connector J14 and has a GPIO function, so remove the PWM1 node and change the GPIO1_IO01 IOMUX to GPIO function. Signed-off-by: Marco Franchi --- arch/arm/boot/dts/imx7d-sdb.dts | 21 +++++++++++++-------- 1 file changed, 13 insertions(+), 8 deletions(-) diff --git a/arch/arm/boot/dts/imx7d-sdb.dts b/arch/arm/boot/dts/imx7d-sdb.dts index 22e106e..b7d0348 100644 --- a/arch/arm/boot/dts/imx7d-sdb.dts +++ b/arch/arm/boot/dts/imx7d-sdb.dts @@ -118,8 +118,19 @@ startup-delay-us = <200000>; }; + reg_lcd_3v3: regulator-lcd-3v3 { + compatible = "regulator-fixed"; + regulator-name = "lcd-3v3"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + gpio = <&extended_io 7 GPIO_ACTIVE_LOW>; + }; + panel { compatible = "innolux,at043tn24"; + pinctrl-0 = <&pinctrl_backlight>; + enable-gpios = <&gpio1 1 GPIO_ACTIVE_HIGH>; + power-supply = <®_lcd_3v3>; port { panel_in: endpoint { @@ -347,12 +358,6 @@ status = "okay"; }; -&pwm1 { - pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_pwm1>; - status = "okay"; -}; - &uart1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart1>; @@ -692,9 +697,9 @@ >; }; - pinctrl_pwm1: pwm1grp { + pinctrl_backlight: backlightgrp { fsl,pins = < - MX7D_PAD_LPSR_GPIO1_IO01__PWM1_OUT 0x110b0 + MX7D_PAD_LPSR_GPIO1_IO01__GPIO1_IO1 0x110b0 >; }; }; -- 2.7.4