From mboxrd@z Thu Jan 1 00:00:00 1970 From: festevam@gmail.com (Fabio Estevam) Date: Mon, 4 Dec 2017 10:20:14 -0200 Subject: [PATCH v2 10/12] ARM: dts: imx6q-h100: Remove unneeded unit address In-Reply-To: <1512390016-703-1-git-send-email-festevam@gmail.com> References: <1512390016-703-1-git-send-email-festevam@gmail.com> Message-ID: <1512390016-703-10-git-send-email-festevam@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org From: Fabio Estevam Remove the unneeded unit address for the port nodes in order to fix the following build warnings with W=1: arch/arm/boot/dts/imx6q-h100.dtb: Warning (unit_address_vs_reg): Node /soc/aips-bus at 2100000/i2c at 21a0000/tc358743 at f/port at 0 has a unit name, but no reg property arch/arm/boot/dts/imx6q-h100.dtb: Warning (unit_address_vs_reg): Node /soc/aips-bus at 2100000/mipi at 21dc000/port at 0 has a unit name, but no reg property Cc: Lucas Stach Signed-off-by: Fabio Estevam --- Changes since v1: - None arch/arm/boot/dts/imx6q-h100.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/imx6q-h100.dts b/arch/arm/boot/dts/imx6q-h100.dts index 743c11f..cc1ce46 100644 --- a/arch/arm/boot/dts/imx6q-h100.dts +++ b/arch/arm/boot/dts/imx6q-h100.dts @@ -205,7 +205,7 @@ reset-gpios = <&gpio6 15 GPIO_ACTIVE_LOW>; /* IRQ has a wrong pull resistor which renders it useless */ - port at 0 { + port { tc358743_out: endpoint { remote-endpoint = <&mipi_csi2_in>; data-lanes = <1 2 3 4>; @@ -348,7 +348,7 @@ &mipi_csi { status = "okay"; - port at 0 { + port { mipi_csi2_in: endpoint { remote-endpoint = <&tc358743_out>; data-lanes = <1 2 3 4>; -- 2.7.4