From mboxrd@z Thu Jan 1 00:00:00 1970 From: stefan.wahren@i2se.com (Stefan Wahren) Date: Fri, 13 Apr 2018 19:27:51 +0200 Subject: [PATCH 2/9] ARM: dts: bcm2837: Add missing GPIOs of Expander In-Reply-To: <1523640478-4448-1-git-send-email-stefan.wahren@i2se.com> References: <1523640478-4448-1-git-send-email-stefan.wahren@i2se.com> Message-ID: <1523640478-4448-3-git-send-email-stefan.wahren@i2se.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org After commit a98d90e7d588 ("gpio: raspberrypi-exp: Driver for RPi3 GPIO expander via mailbox service") we are able to control the rest of the GPIOs of the RPi 3. So add all the missing parts (ACT LED, Wifi & BT control, HDMI detect) to the DT. Signed-off-by: Stefan Wahren --- arch/arm/boot/dts/bcm2837-rpi-3-b.dts | 20 +++++++++++++++++++- 1 file changed, 19 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/bcm2837-rpi-3-b.dts b/arch/arm/boot/dts/bcm2837-rpi-3-b.dts index cc39b6f..c318bcb 100644 --- a/arch/arm/boot/dts/bcm2837-rpi-3-b.dts +++ b/arch/arm/boot/dts/bcm2837-rpi-3-b.dts @@ -20,9 +20,14 @@ leds { act { - gpios = <&gpio 47 GPIO_ACTIVE_HIGH>; + gpios = <&expgpio 2 GPIO_ACTIVE_HIGH>; }; }; + + wifi_pwrseq: wifi-pwrseq { + compatible = "mmc-pwrseq-simple"; + reset-gpios = <&expgpio 1 GPIO_ACTIVE_HIGH>; + }; }; &firmware { @@ -48,6 +53,10 @@ status = "okay"; }; +&hdmi { + hpd-gpios = <&expgpio 4 GPIO_ACTIVE_LOW>; +}; + /* uart0 communicates with the BT module */ &uart0 { pinctrl-names = "default"; @@ -57,6 +66,7 @@ bluetooth { compatible = "brcm,bcm43438-bt"; max-speed = <2000000>; + shutdown-gpios = <&expgpio 0 GPIO_ACTIVE_HIGH>; }; }; @@ -69,11 +79,19 @@ /* SDHCI is used to control the SDIO for wireless */ &sdhci { + #address-cells = <1>; + #size-cells = <0>; pinctrl-names = "default"; pinctrl-0 = <&emmc_gpio34>; status = "okay"; bus-width = <4>; non-removable; + mmc-pwrseq = <&wifi_pwrseq>; + + brcmf: wifi at 1 { + reg = <1>; + compatible = "brcm,bcm4329-fmac"; + }; }; /* SDHOST is used to drive the SD card */ -- 2.7.4