From mboxrd@z Thu Jan 1 00:00:00 1970 From: yossim@codeaurora.org (Yossi Mansharoff) Date: Tue, 17 Apr 2018 16:56:30 +0300 Subject: [PATCH v2] arm64: dts: qcom: Collapse usb support into one node Message-ID: <1523973390-2387-1-git-send-email-yossim@codeaurora.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org We currently have three device nodes for the same USB hardware block, as evident by the reuse of the same reg address multiple times. Now that the chipidea driver fully supports OTG with the MSM wrapper we can collapse all these nodes into one USB device node, reflecting the true nature of the hardware. Signed-off-by: Stephen Boyd --- arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi | 17 ++++++++++++----- 1 file changed, 12 insertions(+), 5 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi index 9ff8487..1505921 100644 --- a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi +++ b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi @@ -18,6 +18,7 @@ #include #include #include +#include /* * GPIO name legend: proper name = the GPIO line is used as GPIO @@ -371,18 +372,18 @@ adp-disable; hnp-disable; srp-disable; - dr_mode = "host"; - pinctrl-names = "default"; - pinctrl-0 = <&usb_sw_sel_pm>; + mux-controls = <&usb_switch>; + mux-control-names = "usb_switch"; + ulpi { phy { v1p8-supply = <&pm8916_l7>; v3p3-supply = <&pm8916_l13>; - extcon = <&usb_id>; }; }; }; + lpass at 7708000 { status = "okay"; }; @@ -512,11 +513,17 @@ usb_id: usb-id { compatible = "linux,extcon-usb-gpio"; - vbus-gpio = <&msmgpio 121 GPIO_ACTIVE_HIGH>; + id-gpio = <&msmgpio 121 GPIO_ACTIVE_HIGH>; pinctrl-names = "default"; pinctrl-0 = <&usb_id_default>; }; + usb_switch: usb-switch { + compatible = "gpio-mux"; + mux-gpios = <&pm8916_gpios 4 GPIO_ACTIVE_HIGH>; + #mux-control-cells = <0>; + }; + hdmi-out { compatible = "hdmi-connector"; type = "a"; -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project