[PATCHv5] omap3: Add basic support for 720MHz part

[laurent.pinchart@ideasonboard.com (Laurent Pinchart)]

Hi,

On Thursday 10 February 2011 08:45:00 Kevin Hilman wrote:
> Sanjeev Premi <premi@ti.com> writes:
> > This patch adds support for speed enhanced variant of OMAP35x
> > processors. These parts allow ARM and IVA running at 720MHz
> > and 520MHz respectively.
> > 
> > These parts can be detected at runtime by reading contents of
> > PRODID.SKUID[3:0] at 0x4830A20C [1].
> > 
> > This patch specifically does following:
> >  * Add new OPP to omap34xx_opp_def_list[] - disabled by default.
> >  * Detect devices capable of running at new OPP.
> >  * Enable new OPP only if device supports it.
> >  * Check for presence of IVA before attempting to enable the
> >  
> >    corresponding OPP.
> >   
> >   [1] http://focus.ti.com/lit/ug/spruff1d/spruff1d.pdf
> > 
> > It appears from discussions (on this patch) that a variant of
> > OMAP3430 supports this OPP but lacks runtime detection. This
> > 
> > OPP can be enabled for these device by either:
> >  1) Setting the bit corresponding to OMAP3_HAS_720MHZ
> >  
> >     in 'omap3_features'. (Refer changes to id.c)
> >  
> >  2) Removing check for omap3_has_720mhz() before enabling
> >  
> >     the OPP. (Refer changes to opp3xxx_data.c)
> >  
> >  3) Calling opp_enable() for 720MHz/VDD1 and 520MHz/VDD2 in
> >  
> >     the board file. (Refer changes to opp3xxx_data.c).
> >     This should, ideally, be done before omap3_opp_init() is
> >     called during device_initcall().
> > 
> > CAUTION: This should be done for identified parts only.
> > 
> >          Else, the device could be damaged permanently.
> > 
> > Signed-off-by: Sanjeev Premi <premi@ti.com>
> > Reviewed-by: G, Manjunath Kondaiah <manjugk@ti.com>
> 
> Acked-by: Kevin Hilman <khilman@ti.com>

This patch seems to never have made it upstream. Is there a reason for that ?

-- 
Regards,

Laurent Pinchart