From: l.stach@pengutronix.de (Lucas Stach)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v3 2/2] PCI: imx: Initial imx7d pm support
Date: Tue, 24 Jul 2018 18:55:41 +0200 [thread overview]
Message-ID: <1532451341.32306.9.camel@pengutronix.de> (raw)
In-Reply-To: <acafccc294f15a281cf1d253c15a3eec2d1c8cc5.1532448745.git.leonard.crestez@nxp.com>
Am Dienstag, den 24.07.2018, 19:14 +0300 schrieb Leonard Crestez:
> On imx7d the pcie-phy power domain is turned off in suspend and this can
> make the system hang after resume when attempting any read from PCI.
>
> Fix this by adding minimal suspend/resume code from the nxp internal
> tree. This will prepare for powering down on suspend and reset the block
> on resume.
>
> Code is only for imx7d but a very similar sequence can be used for
> other socs.
>
> > The original author is mostly Richard Zhu <hongxing.zhu@nxp.com>, this
> patch adjusts the code to the upstream imx7d implemention using reset
> controls and power domains.
>
> Signed-off-by: Leonard Crestez <leonard.crestez@nxp.com>
Reviewed-by: Lucas Stach <l.stach@pengutronix.de>
> ---
> ?drivers/pci/controller/dwc/pci-imx6.c | 97 +++++++++++++++++++++++++--
> ?1 file changed, 92 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/pci/controller/dwc/pci-imx6.c b/drivers/pci/controller/dwc/pci-imx6.c
> index 4a9a673b4777..65b6d1015723 100644
> --- a/drivers/pci/controller/dwc/pci-imx6.c
> +++ b/drivers/pci/controller/dwc/pci-imx6.c
> @@ -540,10 +540,28 @@ static int imx6_pcie_wait_for_speed_change(struct imx6_pcie *imx6_pcie)
> ?
> > ? dev_err(dev, "Speed change timeout\n");
> > ? return -EINVAL;
> ?}
> ?
> +static void imx6_pcie_ltssm_enable(struct device *dev)
> +{
> > + struct imx6_pcie *imx6_pcie = dev_get_drvdata(dev);
> +
> > + switch (imx6_pcie->variant) {
> > + case IMX6Q:
> > + case IMX6SX:
> > + case IMX6QP:
> > + regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR12,
> > + ???IMX6Q_GPR12_PCIE_CTL_2,
> > + ???IMX6Q_GPR12_PCIE_CTL_2);
> > + break;
> > + case IMX7D:
> > + reset_control_deassert(imx6_pcie->apps_reset);
> > + break;
> > + }
> +}
> +
> ?static int imx6_pcie_establish_link(struct imx6_pcie *imx6_pcie)
> ?{
> > ? struct dw_pcie *pci = imx6_pcie->pci;
> > ? struct device *dev = pci->dev;
> > ? u32 tmp;
> @@ -558,15 +576,11 @@ static int imx6_pcie_establish_link(struct imx6_pcie *imx6_pcie)
> > ? tmp &= ~PCIE_RC_LCR_MAX_LINK_SPEEDS_MASK;
> > ? tmp |= PCIE_RC_LCR_MAX_LINK_SPEEDS_GEN1;
> > ? dw_pcie_writel_dbi(pci, PCIE_RC_LCR, tmp);
> ?
> > ? /* Start LTSSM. */
> > - if (imx6_pcie->variant == IMX7D)
> > - reset_control_deassert(imx6_pcie->apps_reset);
> > - else
> > - regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR12,
> > - ???IMX6Q_GPR12_PCIE_CTL_2, 1 << 10);
> > + imx6_pcie_ltssm_enable(dev);
> ?
> > ? ret = imx6_pcie_wait_for_link(imx6_pcie);
> > ? if (ret)
> > ? goto err_reset_phy;
> ?
> @@ -680,10 +694,82 @@ static int imx6_add_pcie_port(struct imx6_pcie *imx6_pcie,
> ?
> ?static const struct dw_pcie_ops dw_pcie_ops = {
> > ? .link_up = imx6_pcie_link_up,
> ?};
> ?
> +#ifdef CONFIG_PM_SLEEP
> +static void imx6_pcie_ltssm_disable(struct device *dev)
> +{
> > + struct imx6_pcie *imx6_pcie = dev_get_drvdata(dev);
> +
> > + switch (imx6_pcie->variant) {
> > + case IMX6SX:
> > + case IMX6QP:
> > + regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR12,
> > + ???IMX6Q_GPR12_PCIE_CTL_2, 0);
> > + break;
> > + case IMX7D:
> > + reset_control_assert(imx6_pcie->apps_reset);
> > + break;
> > + default:
> > + dev_err(dev, "ltssm_disable not supported\n");
> > + }
> +}
> +
> +static void imx6_pcie_clk_disable(struct imx6_pcie *imx6_pcie)
> +{
> > + clk_disable_unprepare(imx6_pcie->pcie);
> > + clk_disable_unprepare(imx6_pcie->pcie_phy);
> > + clk_disable_unprepare(imx6_pcie->pcie_bus);
> +
> > + if (imx6_pcie->variant == IMX7D) {
> > + regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR12,
> > + ???IMX7D_GPR12_PCIE_PHY_REFCLK_SEL,
> > + ???IMX7D_GPR12_PCIE_PHY_REFCLK_SEL);
> > + }
> +}
> +
> +static int imx6_pcie_suspend_noirq(struct device *dev)
> +{
> > + struct imx6_pcie *imx6_pcie = dev_get_drvdata(dev);
> +
> > + if (imx6_pcie->variant != IMX7D)
> > + return 0;
> +
> > + imx6_pcie_clk_disable(imx6_pcie);
> > + imx6_pcie_ltssm_disable(dev);
> +
> > + return 0;
> +}
> +
> +static int imx6_pcie_resume_noirq(struct device *dev)
> +{
> > + int ret;
> > + struct imx6_pcie *imx6_pcie = dev_get_drvdata(dev);
> > + struct pcie_port *pp = &imx6_pcie->pci->pp;
> +
> > + if (imx6_pcie->variant != IMX7D)
> > + return 0;
> +
> > + imx6_pcie_assert_core_reset(imx6_pcie);
> > + imx6_pcie_init_phy(imx6_pcie);
> > + imx6_pcie_deassert_core_reset(imx6_pcie);
> > + dw_pcie_setup_rc(pp);
> +
> > + ret = imx6_pcie_establish_link(imx6_pcie);
> > + if (ret < 0)
> > + dev_info(dev, "pcie link is down after resume.\n");
> +
> > + return 0;
> +}
> +#endif
> +
> +static const struct dev_pm_ops imx6_pcie_pm_ops = {
> > + SET_NOIRQ_SYSTEM_SLEEP_PM_OPS(imx6_pcie_suspend_noirq,
> > + ??????imx6_pcie_resume_noirq)
> +};
> +
> ?static int imx6_pcie_probe(struct platform_device *pdev)
> ?{
> > ? struct device *dev = &pdev->dev;
> > ? struct dw_pcie *pci;
> > ? struct imx6_pcie *imx6_pcie;
> @@ -846,10 +932,11 @@ static const struct of_device_id imx6_pcie_of_match[] = {
> ?static struct platform_driver imx6_pcie_driver = {
> > ? .driver = {
> > > ? .name = "imx6q-pcie",
> > ? .of_match_table = imx6_pcie_of_match,
> > ? .suppress_bind_attrs = true,
> > + .pm = &imx6_pcie_pm_ops,
> > ? },
> > ? .probe????= imx6_pcie_probe,
> > ? .shutdown = imx6_pcie_shutdown,
> ?};
> ?
next prev parent reply other threads:[~2018-07-24 16:55 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-07-24 16:14 [PATCH v3 0/2] PCI: imx: Initial imx7d pm support Leonard Crestez
2018-07-24 16:14 ` [PATCH v3 1/2] Revert "ARM: dts: imx7d: Invert legacy PCI irq mapping" Leonard Crestez
2018-07-24 16:52 ` Lucas Stach
2018-08-21 15:31 ` Shawn Guo
2018-07-24 16:14 ` [PATCH v3 2/2] PCI: imx: Initial imx7d pm support Leonard Crestez
2018-07-24 16:55 ` Lucas Stach [this message]
2018-08-08 10:53 ` [PATCH v3 0/2] " Leonard Crestez
2018-08-08 11:14 ` Lorenzo Pieralisi
2018-08-08 11:37 ` Leonard Crestez
2018-08-08 14:19 ` Lorenzo Pieralisi
2018-08-08 14:58 ` Leonard Crestez
2018-08-08 15:27 ` Lorenzo Pieralisi
2018-08-10 11:11 ` Leonard Crestez
2018-08-10 15:13 ` Lorenzo Pieralisi
2018-08-21 15:26 ` Shawn Guo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1532451341.32306.9.camel@pengutronix.de \
--to=l.stach@pengutronix.de \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).