From mboxrd@z Thu Jan 1 00:00:00 1970 From: Andrei.Stefanescu@microchip.com (Andrei.Stefanescu at microchip.com) Date: Tue, 20 Nov 2018 08:08:36 +0000 Subject: [PATCH v2 1/2] dt-bindings: gpio: add SAMA5D2 PIOBU support In-Reply-To: <1542701330-23466-1-git-send-email-andrei.stefanescu@microchip.com> References: <1542701330-23466-1-git-send-email-andrei.stefanescu@microchip.com> Message-ID: <1542701330-23466-2-git-send-email-andrei.stefanescu@microchip.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch describes the compatible and the device tree bindings necessary for the SAMA5D2 PIOBU GPIO. Signed-off-by: Andrei Stefanescu --- .../bindings/gpio/gpio-sama5d2-piobu.txt | 31 ++++++++++++++++++++++ 1 file changed, 31 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt diff --git a/Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt b/Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt new file mode 100644 index 0000000..2e260e1 --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt @@ -0,0 +1,31 @@ +GPIO controller for SAMA5D2 PIOBU pins. + +These pins have the property of not losing their voltage +during Backup/Self-refresh mode. + +These bindings should be set to a node in the dtsi file. + +Required properties: +- compatible: "syscon", "microchip,sama5d2-piobu" +- #gpio-cells: There are 2. The pin number is the + first, the second represents additional + parameters such as GPIO_ACTIVE_HIGH/LOW. +- gpio-controller: Marks the port as GPIO controller. + +Note that the driver uses syscon and should be the child of +the syscon node. + +Example: + + secumod at fc040000 { + compatible = "atmel,sama5d2-secumod", "syscon", "simple-mfd"; + status = "okay"; + reg = <0xfc040000 0x100>; + + pioBU: piobu { + status = "okay"; + compatible = "microchip,sama5d2-piobu"; + gpio-controller; + #gpio-cells = <2>; + }; + }; -- 2.7.4