Re: [PATCH v5 01/20] dt-bindings: mediatek: Add binding for mt8183 IOMMU and SMI

[Yong Wu <yong.wu@mediatek.com>]

Hi Evan,

Thanks very much for reviewing this patchset.

On Wed, 2019-01-30 at 10:27 -0800, Evan Green wrote:
> On Mon, Dec 31, 2018 at 7:56 PM Yong Wu <yong.wu@mediatek.com> wrote:
> >
> > This patch adds decriptions for mt8183 IOMMU and SMI.
> >
> > mt8183 has only one M4U like mt8173 and is also MTK IOMMU gen2 which
> > uses ARM Short-Descriptor translation table format.
> >
> > The mt8183 M4U-SMI HW diagram is as below:
> >
> >                           EMI
> >                            |
> >                           M4U
> >                            |
> >                        ----------
> >                        |        |
> >                    gals0-rx   gals1-rx
> >                        |        |
> >                        |        |
> >                    gals0-tx   gals1-tx
> >                        |        |
> >                       ------------
> >                        SMI Common
> >                       ------------
> >                            |
> >   +-----+-----+--------+-----+-----+-------+-------+
> >   |     |     |        |     |     |       |       |
> >   |     |  gals-rx  gals-rx  |   gals-rx gals-rx gals-rx
> >   |     |     |        |     |     |       |       |
> >   |     |     |        |     |     |       |       |
> >   |     |  gals-tx  gals-tx  |   gals-tx gals-tx gals-tx
> >   |     |     |        |     |     |       |       |
> > larb0 larb1  IPU0    IPU1  larb4  larb5  larb6    CCU
> > disp  vdec   img     cam    venc   img    cam
> 
> It might be cool to put the gals in the picture in the bindings. Not a
> big deal though.

OK. the picture in the binding should be more generic, I will try add
gals in the binding picture in next version.

> 
> >
> > All the connections are HW fixed, SW can NOT adjust it.
> >
> > Compared with mt8173, we add a GALS(Global Async Local Sync) module
> > between SMI-common and M4U, and additional GALS between larb2/3/5/6
> > and SMI-common. GALS can help synchronize for the modules in different
> > clock frequency, it can be seen as a "asynchronous fifo".
> >
> > GALS can only help transfer the command/data while it doesn't have
> > the configuring register, thus it has the special "smi" clock and it
> > doesn't have the "apb" clock. From the diagram above, we add "gals0"
> > and "gals1" clocks for smi-common and add a "gals" clock for smi-larb.
> >
> > From the diagram above, IPU0/IPU1(Image Processor Unit) and CCU(Camera
> > Control Unit) is connected with smi-common directly, we can take them
> > as "larb2", "larb3" and "larb7", and their register spaces are
> > different with the normal larb.
> >
> > Signed-off-by: Yong Wu <yong.wu@mediatek.com>
> > Reviewed-by: Rob Herring <robh@kernel.org>
> > ---
> >  .../devicetree/bindings/iommu/mediatek,iommu.txt   |  15 ++-
> >  .../memory-controllers/mediatek,smi-common.txt     |  11 +-
> >  .../memory-controllers/mediatek,smi-larb.txt       |   3 +
> >  include/dt-bindings/memory/mt8183-larb-port.h      | 130 +++++++++++++++++++++
> >  4 files changed, 153 insertions(+), 6 deletions(-)
> >  create mode 100644 include/dt-bindings/memory/mt8183-larb-port.h
> >
> > diff --git a/Documentation/devicetree/bindings/iommu/mediatek,iommu.txt b/Documentation/devicetree/bindings/iommu/mediatek,iommu.txt
> > index 6922db5..6e758996 100644
> > --- a/Documentation/devicetree/bindings/iommu/mediatek,iommu.txt
> > +++ b/Documentation/devicetree/bindings/iommu/mediatek,iommu.txt
> > @@ -36,6 +36,10 @@ each local arbiter.
> >  like display, video decode, and camera. And there are different ports
> >  in each larb. Take a example, There are many ports like MC, PP, VLD in the
> >  video decode local arbiter, all these ports are according to the video HW.
> > +  In some SoCs, there may be a GALS(Global Async Local Sync) module between
> > +smi-common and m4u, and additional GALS module between smi-larb and
> > +smi-common. GALS can been seen as a "asynchronous fifo" which could help
> > +synchronize for the modules in different clock frequency.
> >
> >  Required properties:
> >  - compatible : must be one of the following string:
> > @@ -44,18 +48,23 @@ Required properties:
> >         "mediatek,mt7623-m4u", "mediatek,mt2701-m4u" for mt7623 which uses
> >                                                      generation one m4u HW.
> >         "mediatek,mt8173-m4u" for mt8173 which uses generation two m4u HW.
> > +       "mediatek,mt8183-m4u" for mt8183 which uses generation two m4u HW.
> >  - reg : m4u register base and size.
> >  - interrupts : the interrupt of m4u.
> >  - clocks : must contain one entry for each clock-names.
> > -- clock-names : must be "bclk", It is the block clock of m4u.
> > +- clock-names : Only 1 optional clock:
> > +  - "bclk": the block clock of m4u.
> > +  Note that m4u use the EMI clock which always has been enabled before kernel
> > +  if there is no this "bclk".
> 
> Ideally bclk could be specified a little more crisply, as this is
> actually required for some SoCs and not used at all on others (as in
> patch 7).

OK. I will add like this:

+ Here is the list which require the "bclk":
+   - mt2701, mt2712, mt7623 and mt8173. 

> 
> >  - mediatek,larbs : List of phandle to the local arbiters in the current Socs.
> >         Refer to bindings/memory-controllers/mediatek,smi-larb.txt. It must sort
> >         according to the local arbiter index, like larb0, larb1, larb2...
> >  - iommu-cells : must be 1. This is the mtk_m4u_id according to the HW.
> >         Specifies the mtk_m4u_id as defined in
> >         dt-binding/memory/mt2701-larb-port.h for mt2701, mt7623
> > -       dt-binding/memory/mt2712-larb-port.h for mt2712, and
> > -       dt-binding/memory/mt8173-larb-port.h for mt8173.
> > +       dt-binding/memory/mt2712-larb-port.h for mt2712,
> > +       dt-binding/memory/mt8173-larb-port.h for mt8173, and
> > +       dt-binding/memory/mt8183-larb-port.h for mt8183.
> >
> >  Example:
> >         iommu: iommu@10205000 {
> > diff --git a/Documentation/devicetree/bindings/memory-controllers/mediatek,smi-common.txt b/Documentation/devicetree/bindings/memory-controllers/mediatek,smi-common.txt
> > index e937ddd..8d3240a 100644
> > --- a/Documentation/devicetree/bindings/memory-controllers/mediatek,smi-common.txt
> > +++ b/Documentation/devicetree/bindings/memory-controllers/mediatek,smi-common.txt
> > @@ -2,9 +2,10 @@ SMI (Smart Multimedia Interface) Common
> >
> >  The hardware block diagram please check bindings/iommu/mediatek,iommu.txt
> >
> > -Mediatek SMI have two generations of HW architecture, mt2712 and mt8173 use
> > -the second generation of SMI HW while mt2701 uses the first generation HW of
> > -SMI.
> > +Mediatek SMI have two generations of HW architecture, here is the list
> > +which generation the Socs use:
> > +generation 1: mt2701 and mt7623.
> > +generation 2: mt2712, mt8173 and mt8183.
> >
> >  There's slight differences between the two SMI, for generation 2, the
> >  register which control the iommu port is at each larb's register base. But
> > @@ -19,6 +20,7 @@ Required properties:
> >         "mediatek,mt2712-smi-common"
> >         "mediatek,mt7623-smi-common", "mediatek,mt2701-smi-common"
> >         "mediatek,mt8173-smi-common"
> > +       "mediatek,mt8183-smi-common"
> >  - reg : the register and size of the SMI block.
> >  - power-domains : a phandle to the power domain of this local arbiter.
> >  - clocks : Must contain an entry for each entry in clock-names.
> > @@ -30,6 +32,9 @@ Required properties:
> >             They may be the same if both source clocks are the same.
> >    - "async" : asynchronous clock, it help transform the smi clock into the emi
> >               clock domain, this clock is only needed by generation 1 smi HW.
> > +  and these 2 option clocks for generation 2 smi HW:
> > +  - "gals0": the path0 clock of GALS(Global Async Local Sync).
> > +  - "gals1": the path1 clock of GALS(Global Async Local Sync).
> 
> It would also be nice to specify these more clearly too, since these
> are also required for some SoCs and not used on others (as in patch
> 12).

I will add:

+ Here is the list which has the "gals": mt8183.



_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel