[PATCH] clk: imx: clk-pllv3: Use readl_poll_timeout() for PLL lock wait

[Anson Huang <Anson.Huang@nxp.com>]

Use readl_poll_timeout() for PLL lock wait which can simplify the
code a lot.

Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
---
 drivers/clk/imx/clk-pllv3.c | 16 +++++-----------
 1 file changed, 5 insertions(+), 11 deletions(-)

diff --git a/drivers/clk/imx/clk-pllv3.c b/drivers/clk/imx/clk-pllv3.c
index df91a82..3dfa9c3 100644
--- a/drivers/clk/imx/clk-pllv3.c
+++ b/drivers/clk/imx/clk-pllv3.c
@@ -7,6 +7,7 @@
 #include <linux/clk-provider.h>
 #include <linux/delay.h>
 #include <linux/io.h>
+#include <linux/iopoll.h>
 #include <linux/slab.h>
 #include <linux/jiffies.h>
 #include <linux/err.h>
@@ -25,6 +26,8 @@
 #define IMX7_ENET_PLL_POWER	(0x1 << 5)
 #define IMX7_DDR_PLL_POWER	(0x1 << 20)
 
+#define PLL_LOCK_TIMEOUT	10000
+
 /**
  * struct clk_pllv3 - IMX PLL clock version 3
  * @clk_hw:	 clock source
@@ -53,23 +56,14 @@ struct clk_pllv3 {
 
 static int clk_pllv3_wait_lock(struct clk_pllv3 *pll)
 {
-	unsigned long timeout = jiffies + msecs_to_jiffies(10);
 	u32 val = readl_relaxed(pll->base) & pll->power_bit;
 
 	/* No need to wait for lock when pll is not powered up */
 	if ((pll->powerup_set && !val) || (!pll->powerup_set && val))
 		return 0;
 
-	/* Wait for PLL to lock */
-	do {
-		if (readl_relaxed(pll->base) & BM_PLL_LOCK)
-			break;
-		if (time_after(jiffies, timeout))
-			break;
-		usleep_range(50, 500);
-	} while (1);
-
-	return readl_relaxed(pll->base) & BM_PLL_LOCK ? 0 : -ETIMEDOUT;
+	return readl_poll_timeout(pll->base, val, val & BM_PLL_LOCK, 500,
+				  PLL_LOCK_TIMEOUT);
 }
 
 static int clk_pllv3_prepare(struct clk_hw *hw)
-- 
2.7.4


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel