Re: [PATCH 01/12] dt-bindings: phy: Document MT8195 and MT8196 DisplayPort PHYs

["Rob Herring (Arm)" <robh@kernel.org>]

On Wed, 01 Jul 2026 14:19:57 +0200, AngeloGioacchino Del Regno wrote:
> This adds bindings for the DisplayPort and Embedded DisplayPort
> PHYs found in the MediaTek MT8195 SoC (and variants of) and for
> the Embedded DisplayPort found in the MT8196 SoC (and variants).
> 
> This PHY supports varying impedance calibrations for the various
> signals to reach an optimal EYE signal pattern for any specific
> board(s), especially useful for very high bitrates such as HBR3
> and higher, depending on board design.
> 
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
> ---
>  .../bindings/phy/mediatek,mt8195-dp-phy.yaml  | 77 +++++++++++++++++++
>  1 file changed, 77 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/mediatek,mt8195-dp-phy.yaml
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/phy/mediatek,mt8195-dp-phy.example.dtb: phy@1c500000 (mediatek,mt8195-dp-phy): reg: [[0, 475004928], [0, 8192]] is too long
	from schema $id: http://devicetree.org/schemas/phy/mediatek,mt8195-dp-phy.yaml

doc reference errors (make refcheckdocs):

See https://patchwork.kernel.org/project/devicetree/patch/20260701122008.19509-2-angelogioacchino.delregno@collabora.com

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.