[PATCH 27/33] Removing dead IDE_PXA_CF

[marek.vasut@gmail.com (Marek Vasut)]

Dne P? 2. ?ervence 2010 09:45:41 Juergen Schindele napsal(a):
> Am Donnerstag, 1. Juli 2010 schrieb Eric Miao:
> > On Thu, Jul 1, 2010 at 12:02 AM, Christoph Egger <siccegge@cs.fau.de> wrote:
> > > IDE_PXA_CF doesn't exist in Kconfig, therefore removing all references
> > > for it from the source code.
> > > 
> > > Signed-off-by: Christoph Egger <siccegge@cs.fau.de>
> > 
> > Acked-by: Eric Miao <eric.y.miao@gmail.com>
> > 
> > Include Jurgen though, in case he has any idea.
> > 
> > > ---
> > >  arch/arm/mach-pxa/trizeps4.c |    6 +-----
> > >  1 files changed, 1 insertions(+), 5 deletions(-)
> > > 
> > > diff --git a/arch/arm/mach-pxa/trizeps4.c
> > > b/arch/arm/mach-pxa/trizeps4.c index 6968911..0acff17 100644
> > > --- a/arch/arm/mach-pxa/trizeps4.c
> > > +++ b/arch/arm/mach-pxa/trizeps4.c
> > > @@ -530,13 +530,9 @@ static void __init trizeps4_init(void)
> > >        i2c_register_board_info(0, trizeps4_i2c_devices,
> > >                                      
> > >  ARRAY_SIZE(trizeps4_i2c_devices));
> 
> Its OK for me to remove this because i can use pata_platform
> instead and a rework of trizeps4/5 is planned.
> Recently it was very hard for me to follow all changes.

Are you using U-Boot on that trizeps V ? btw. maybe you can even use pata-pxa if 
your hardware supports pxa dma?

Cheers
> 
> > > -#ifdef CONFIG_IDE_PXA_CF
> > > -       /* if boot direct from compact flash dont disable power */
> > > -       trizeps_conxs_bcr = 0x0009;
> > > -#else
> > >        /* this is the reset value */
> > >        trizeps_conxs_bcr = 0x00A0;
> > > -#endif
> > > +
> > >        BCR_writew(trizeps_conxs_bcr);
> > >        board_backlight_power(1);
> > >  }
> > > --
> > > 1.7.0.4
> > 
> > _______________________________________________
> > linux-arm-kernel mailing list
> > linux-arm-kernel at lists.infradead.org
> > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel