From mboxrd@z Thu Jan 1 00:00:00 1970 From: u.kleine-koenig@pengutronix.de (Uwe =?iso-8859-1?Q?Kleine-K=F6nig?=) Date: Thu, 9 Dec 2010 08:04:11 +0100 Subject: [PATCH 1/6] ARM: mx5: use config to define boot related addresses In-Reply-To: <1291903716-31388-1-git-send-email-richard.zhao@freescale.com> References: <1291903716-31388-1-git-send-email-richard.zhao@freescale.com> Message-ID: <20101209070411.GH17441@pengutronix.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hello, On Thu, Dec 09, 2010 at 10:08:31PM +0800, Richard Zhao wrote: > Signed-off-by: Richard Zhao > --- > This series of patch support mx50 reference design board. I've tested it using > initramfs on the board. > > arch/arm/mach-mx5/Makefile.boot | 6 +++--- > 1 files changed, 3 insertions(+), 3 deletions(-) > > diff --git a/arch/arm/mach-mx5/Makefile.boot b/arch/arm/mach-mx5/Makefile.boot > index 9939a19..388d2e8 100644 > --- a/arch/arm/mach-mx5/Makefile.boot > +++ b/arch/arm/mach-mx5/Makefile.boot > @@ -1,3 +1,3 @@ > - zreladdr-y := 0x90008000 > -params_phys-y := 0x90000100 > -initrd_phys-y := 0x90800000 > + zreladdr-$(CONFIG_SOC_IMX51) := 0x90008000 > +params_phys-$(CONFIG_SOC_IMX51) := 0x90000100 > +initrd_phys-$(CONFIG_SOC_IMX51) := 0x90800000 That is one of the places that is not multi-soc capable. You can make it 66% less worse by just removing params_phys and initrd_phys. Best regards Uwe -- Pengutronix e.K. | Uwe Kleine-K?nig | Industrial Linux Solutions | http://www.pengutronix.de/ |