[PATCH] mmci: partially revert clock divisor code

Linus Walleij
2010-12-09T08:52:55Z

I misread the datasheet as if bypass mode was not available at all
on the ux500's, I was wrong. It is there, the datasheet just
states that you should not have to use it.

Signed-off-by: Linus Walleij <linus.walleij@stericsson.com>
---
drivers/mmc/host/mmci.c | 8 +-------
1 files changed, 1 insertions(+), 7 deletions(-)

diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index 82880e8..907e582 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -101,13 +101,7 @@ static void mmci_set_clkreg(struct mmci_host *host, unsigned int desired)

if (desired) {
if (desired >= host->mclk) {
- /*
- * The ST clock divider does not like the bypass bit,
- * even though it's available. Instead the datasheet
- * recommends setting the divider to zero.
- */
- if (!variant->st_clkdiv)
- clk = MCI_CLK_BYPASS;
+ clk = MCI_CLK_BYPASS;
host->cclk = host->mclk;
} else if (variant->st_clkdiv) {
/*
--
1.7.3.2