From mboxrd@z Thu Jan 1 00:00:00 1970 From: s.hauer@pengutronix.de (Sascha Hauer) Date: Thu, 6 Jan 2011 11:16:39 +0100 Subject: [PATCH v4 5/8] arm: mxc: move IOMUX_CONFIG_XXXX definitions to iomux-v3.h In-Reply-To: <20110106065935.GA15509@shlinux1.ap.freescale.net> References: <1293708306-20170-1-git-send-email-richard.zhao@freescale.com> <1293708306-20170-2-git-send-email-richard.zhao@freescale.com> <1293708306-20170-3-git-send-email-richard.zhao@freescale.com> <1293708306-20170-4-git-send-email-richard.zhao@freescale.com> <1293708306-20170-5-git-send-email-richard.zhao@freescale.com> <20110106065935.GA15509@shlinux1.ap.freescale.net> Message-ID: <20110106101639.GE26009@pengutronix.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Thu, Jan 06, 2011 at 02:59:36PM +0800, Richard Zhao wrote: > Hello Sascha, > > On Thu, Dec 30, 2010 at 07:25:04PM +0800, Richard Zhao wrote: > > IOMUX_CONFIG_GPIO is not for iomux-v3. It's for old freescale > > iomux routines. Remove it. > > > > Signed-off-by: Richard Zhao > > Acked-by: Uwe Kleine-K?nig > If you don't have comments, could you please merge this patch? > It's causing arch/arm/plat-mxc/include/mach/iomux-mx50.h incomplete. I didn't apply it because it conflicts with current imx-for-2.6.38 branch. Other than that I don't find the enum very useful at all, because we have problems with very long lines in these files and using IOMUX_CONFIG_ALT0 where we could use 0 does not exactly improve the situation. Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |