From: ben-i2c@fluff.org (Ben Dooks)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH] i2c: OMAP: fix static suspend vs. runtime suspend
Date: Sat, 5 Feb 2011 16:08:43 +0000 [thread overview]
Message-ID: <20110205160843.GD15795@trinity.fluff.org> (raw)
In-Reply-To: <1296173921-4832-1-git-send-email-khilman@ti.com>
On Thu, Jan 27, 2011 at 04:18:41PM -0800, Kevin Hilman wrote:
> When runtime PM is enabled, each OMAP i2c device is suspended after
> each i2c xfer. However, there are two cases when the static suspend
> methods must be used to ensure the devices are suspended:
>
> 1) runtime PM is disabled, either at compile time or dynamically
> via /sys/devices/.../power/control.
> 2) an i2c client driver uses i2c during it's suspend callback, thus
> leaving the i2c driver active (NOTE: runtime suspend transitions are
> disabled during system suspend, so i2c activity during system
> suspend will runtime resume the device, but not runtime (re)suspend it.)
>
> Since the actual work to suspend the device is handled by the
> subsytem, call the bus methods to take care of it.
>
> NOTE: This takes care of a known suspend problem on OMAP3 where the
> TWL RTC driver does i2c xfers during its suspend path leaving the i2c
> driver in an active state (since runtime suspend transistions are
> disabled.)
>
> Signed-off-by: Kevin Hilman <khilman@ti.com>
> ---
> Ben, this is a regression in 2.6.38 so hopefully this can be queued
> in the 2.6.38-rc cycle. Thanks.
Ok, after all the discussions should I keep it in my -rc queue?
> drivers/i2c/busses/i2c-omap.c | 28 ++++++++++++++++++++++++++++
> 1 files changed, 28 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
> index b605ff3..0541df9 100644
> --- a/drivers/i2c/busses/i2c-omap.c
> +++ b/drivers/i2c/busses/i2c-omap.c
> @@ -1137,12 +1137,40 @@ omap_i2c_remove(struct platform_device *pdev)
> return 0;
> }
>
> +#ifdef CONFIG_SUSPEND
> +static int omap_i2c_suspend(struct device *dev)
> +{
> + if (!pm_runtime_suspended(dev))
> + if (dev->bus && dev->bus->pm && dev->bus->pm->runtime_suspend)
> + dev->bus->pm->runtime_suspend(dev);
> +
> + return 0;
> +}
> +
> +static int omap_i2c_resume(struct device *dev)
> +{
> + if (!pm_runtime_suspended(dev))
> + if (dev->bus && dev->bus->pm && dev->bus->pm->runtime_resume)
> + dev->bus->pm->runtime_resume(dev);
> +
> + return 0;
> +}
> +
> +static struct dev_pm_ops omap_i2c_pm_ops = {
> + .suspend = omap_i2c_suspend,
> + .resume = omap_i2c_resume,
> +};
> +#else
> +#define omap_i2c_pm_ops NULL
> +#endif
> +
> static struct platform_driver omap_i2c_driver = {
> .probe = omap_i2c_probe,
> .remove = omap_i2c_remove,
> .driver = {
> .name = "omap_i2c",
> .owner = THIS_MODULE,
> + .pm = &omap_i2c_pm_ops,
> },
> };
>
> --
> 1.7.3.5
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
> the body of a message to majordomo at vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
Ben Dooks, ben at fluff.org, http://www.fluff.org/ben/
Large Hadron Colada: A large Pina Colada that makes the universe disappear.
next prev parent reply other threads:[~2011-02-05 16:08 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-01-28 0:18 [PATCH] i2c: OMAP: fix static suspend vs. runtime suspend Kevin Hilman
2011-01-31 11:28 ` Rajendra Nayak
2011-01-31 15:13 ` [linux-pm] " Alan Stern
2011-01-31 15:28 ` Rajendra Nayak
2011-01-31 16:09 ` Kevin Hilman
2011-01-31 16:22 ` Alan Stern
2011-01-31 18:19 ` Rafael J. Wysocki
2011-02-11 20:00 ` [PATCH] PM: Allow pm_runtime_suspend() to succeed during system suspend Rafael J. Wysocki
2011-02-11 20:36 ` Alan Stern
2011-02-11 20:38 ` Kevin Hilman
2011-02-11 21:25 ` Rafael J. Wysocki
2011-02-11 23:45 ` Kevin Hilman
2011-02-12 0:00 ` Rafael J. Wysocki
2011-02-05 16:08 ` Ben Dooks [this message]
2011-02-08 18:31 ` [PATCH] i2c: OMAP: fix static suspend vs. runtime suspend Kevin Hilman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20110205160843.GD15795@trinity.fluff.org \
--to=ben-i2c@fluff.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).