From mboxrd@z Thu Jan 1 00:00:00 1970 From: hjk@hansjkoch.de (Hans J. Koch) Date: Tue, 1 Mar 2011 19:33:35 +0100 Subject: [PATCH v6 1/1] PRUSS UIO driver support In-Reply-To: References: <1298926895-5294-1-git-send-email-pratheesh@ti.com> <1298926895-5294-2-git-send-email-pratheesh@ti.com> <20110228212638.GB16806@local> Message-ID: <20110301183334.GC20497@local> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Mar 01, 2011 at 10:15:27AM +0530, TK, Pratheesh Gangadhar wrote: > Hi, > > > -----Original Message----- > > From: Hans J. Koch [mailto:hjk at hansjkoch.de] > > Sent: Tuesday, March 01, 2011 2:57 AM > > To: TK, Pratheesh Gangadhar > > Cc: linux-kernel at vger.kernel.org; hjk at hansjkoch.de; gregkh at suse.de; > > tglx at linutronix.de; sshtylyov at mvista.com; arnd at arndb.de; Chatterjee, Amit; > > davinci-linux-open-source at linux.davincidsp.com; linux-arm- > > kernel at lists.infradead.org > > Subject: Re: [PATCH v6 1/1] PRUSS UIO driver support > > > > On Tue, Mar 01, 2011 at 02:31:35AM +0530, Pratheesh Gangadhar wrote: > > > + > > > + /* Register PRUSS IRQ lines */ > > > + p->irq = IRQ_DA8XX_EVTOUT0 + cnt; > > > + p->handler = pruss_handler; > > > + > > > + ret = uio_register_device(&dev->dev, p); > > > + > > > + if (ret < 0) > > > + goto out_free; > > > + } > > > + > > > + spin_lock_init(&lock); > > > > That's too late. uio_register_device() enables the irq, and your spin_lock > > is not ready at that time. > > This is ok in this context as "modprobe uio_pruss" is pre-requisite for > running PRUSS firmware and without firmware running PRUSS won't > generate interrupts. Actually PRUSS INTC is not setup till we start > user application. What if the user application is stopped, UIO driver module unloaded and loaded again? Anyway, please don't use that kind of argumentation. The next newbie developer might copy your work as a basis for his new driver, and there it probably won't work. Simply put the spin_lock_init before the loop. Thanks, Hans