[PATCH 2/2] gpio/mxc: add device tree probe support

[grant.likely@secretlab.ca (Grant Likely)]

On Sun, Jul 03, 2011 at 04:16:57PM +0800, Shawn Guo wrote:
> The patch adds device tree probe support for gpio-mxc driver.
> 
> Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
> Cc: Grant Likely <grant.likely@secretlab.ca>

Hi Shawn,

comments below.

g.

> ---
>  .../devicetree/bindings/gpio/fsl-imx-gpio.txt      |   22 ++++++++++
>  drivers/gpio/gpio-mxc.c                            |   42 +++++++++++++++++++-
>  2 files changed, 63 insertions(+), 1 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/gpio/fsl-imx-gpio.txt
> 
> diff --git a/Documentation/devicetree/bindings/gpio/fsl-imx-gpio.txt b/Documentation/devicetree/bindings/gpio/fsl-imx-gpio.txt
> new file mode 100644
> index 0000000..4363ae4
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/fsl-imx-gpio.txt
> @@ -0,0 +1,22 @@
> +* Freescale i.MX/MXC GPIO controller
> +
> +Required properties:
> +- compatible : Should be "fsl,<soc>-gpio"
> +- reg : Address and length of the register set for the device
> +- interrupts : Should be the port interrupt shared by all 32 pins, if
> +  one number.  If two numbers, the first one is the interrupt shared
> +  by low 16 pins and the second one is for high 16 pins.
> +- gpio-controller : Marks the device node as a gpio controller.
> +- #gpio-cells : Should be two.  The first cell is the pin number and
> +  the second cell is used to specify optional parameters (currently
> +  unused).
> +
> +Example:
> +
> +gpio0: gpio at 73f84000 {
> +	compatible = "fsl,imx51-gpio", "fsl,imx31-gpio";
> +	reg = <0x73f84000 0x4000>;
> +	interrupts = <50 51>;
> +	gpio-controller;
> +	#gpio-cells = <2>;
> +};
> diff --git a/drivers/gpio/gpio-mxc.c b/drivers/gpio/gpio-mxc.c
> index 7ae71d6..b42204f 100644
> --- a/drivers/gpio/gpio-mxc.c
> +++ b/drivers/gpio/gpio-mxc.c
> @@ -27,6 +27,8 @@
>  #include <linux/platform_device.h>
>  #include <linux/slab.h>
>  #include <linux/basic_mmio_gpio.h>
> +#include <linux/of.h>
> +#include <linux/of_device.h>
>  #include <asm-generic/bug.h>
>  
>  enum mxc_gpio_type {
> @@ -141,6 +143,13 @@ static struct platform_device_id mxc_gpio_devtype[] = {
>  	}
>  };
>  
> +static const struct of_device_id mxc_gpio_dt_ids[] = {
> +	{ .compatible = "fsl,imx1-gpio", .data = &mxc_gpio_devdata[IMX1_GPIO], },
> +	{ .compatible = "fsl,imx2-gpio", .data = &mxc_gpio_devdata[IMX2_GPIO], },
> +	{ .compatible = "fsl,imx31-gpio", .data = &mxc_gpio_devdata[IMX_GPIO], },
> +	{ /* sentinel */ },
> +};
> +
>  /*
>   * MX2 has one interrupt *for all* gpio ports. The list is used
>   * to save the references to all ports, so that mx2_gpio_irq_handler
> @@ -321,6 +330,33 @@ static void __init mxc_gpio_init_gc(struct mxc_gpio_port *port)
>  			       IRQ_NOREQUEST, 0);
>  }
>  
> +#ifdef CONFIG_OF
> +static int mxc_gpio_probe_dt(struct mxc_gpio_port *port,
> +			     struct platform_device *pdev)
> +{
> +	struct device_node *np = pdev->dev.of_node;
> +	const struct of_device_id *of_id =
> +			of_match_device(mxc_gpio_dt_ids, &pdev->dev);
> +
> +	if (!np)
> +		return -ENODEV;
> +
> +	pdev->id = of_alias_get_id(np, "gpio");
> +	if (pdev->id < 0)
> +		return -ENODEV;

I really doubt this is wanted or needed.  First, after a
platform_device is registered, pdev->id is immutable.  It must not be
changed.

Second, when using the DT, there is absolutely no need for a preset
range of gpio numbers.  The gpio core assigns ranges dynamically, and
all GPIO references are via device tree phandles that don't use the
Linux global gpio number space.

The driver needs to be fixed to dynamically assign its gpio range when
probed from the DT.

> +
> +	port->devdata = of_id->data;
> +
> +	return 0;
> +}
> +#else
> +static inline int mxc_gpio_probe_dt(struct mxc_gpio_port *port,
> +				    struct platform_device *pdev)
> +{
> +	return -ENODEV;
> +}
> +#endif
> +
>  static int __devinit mxc_gpio_probe(struct platform_device *pdev)
>  {
>  	struct mxc_gpio_port *port;
> @@ -331,7 +367,10 @@ static int __devinit mxc_gpio_probe(struct platform_device *pdev)
>  	if (!port)
>  		return -ENOMEM;
>  
> -	port->devdata = &mxc_gpio_devdata[pdev->id_entry->driver_data];
> +	err = mxc_gpio_probe_dt(port, pdev);
> +	if (err == -ENODEV)
> +		port->devdata = &mxc_gpio_devdata[pdev->id_entry->driver_data];
> +

What if id_entry is NULL?

>  	port->virtual_irq_start = MXC_GPIO_IRQ_START + pdev->id * 32;
>  
>  	iores = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> @@ -416,6 +455,7 @@ static struct platform_driver mxc_gpio_driver = {
>  	.driver		= {
>  		.name	= "gpio-mxc",
>  		.owner	= THIS_MODULE,
> +		.of_match_table = mxc_gpio_dt_ids,
>  	},
>  	.probe		= mxc_gpio_probe,
>  	.id_table	= mxc_gpio_devtype,
> -- 
> 1.7.4.1
>