[PATCH v4 18/20] gpio/omap: use pm-runtime framework

[toddpoynor@google.com (Todd Poynor)]

On Wed, Jul 13, 2011 at 07:24:17PM +0530, Tarun Kanti DebBarma wrote:
> From: Charulatha V <charu@ti.com>
> 
> Call runtime pm APIs pm_runtime_get_sync() and pm_runtime_put_sync()
> for enabling/disabling clocks appropriately. Remove syscore_ops and
> instead use dev_pm_ops now.
> 
...
> +	/*
> +	 * If this is the first gpio_request for the bank,
> +	 * enable the bank module.
> +	 */
> +	if (!bank->mod_usage) {
> +		if (IS_ERR_VALUE(pm_runtime_get_sync(bank->dev) < 0)) {
> +			dev_err(bank->dev, "%s: GPIO bank %d "
> +					"pm_runtime_get_sync failed\n",
> +					__func__, bank->id);
> +			return -EINVAL;
> +		}
> +
> +		/* Initialize the gpio bank registers to init time value */
> +		omap_gpio_mod_init(bank);
> +	}
> +
>  	spin_lock_irqsave(&bank->lock, flags);

Does the check for first gpio_request and omap_gpio_mod_init() call
need concurrency protection, possibly moved under the spinlock?

>  
>  	/* Set trigger to none. You need to enable the desired trigger with
> @@ -536,6 +554,18 @@ static void omap_gpio_free(struct gpio_chip *chip, unsigned offset)
>  
>  	_reset_gpio(bank, bank->chip.base + offset);
>  	spin_unlock_irqrestore(&bank->lock, flags);
> +
> +	/*
> +	 * If this is the last gpio to be freed in the bank,
> +	 * disable the bank module.
> +	 */
> +	if (!bank->mod_usage) {
> +		if (IS_ERR_VALUE(pm_runtime_put_sync(bank->dev) < 0)) {
> +			dev_err(bank->dev, "%s: GPIO bank %d "
> +					"pm_runtime_put_sync failed\n",
> +					__func__, bank->id);
> +		}
> +	}

And need mutual exclusion here?


Todd