[PATCH] Improve slave/cyclic DMA engine documentation (was: [PATCH V4 04/14] DMA: PL330: Add DMA_CYCLIC capability)

[linux@arm.linux.org.uk (Russell King - ARM Linux)]

On Tue, Jul 26, 2011 at 03:05:33PM +0530, Vinod Koul wrote:
> On Tue, 2011-07-26 at 08:57 +0100, Russell King - ARM Linux wrote:
> > Here's an updated patch.
> > 
> > 8<----------
> > From: Russell King <rmk+kernel@arm.linux.org.uk>
> > DMAEngine: Improve slave/cyclic documentation
> > 
> > Improve the documentation for the slave and cyclic DMA engine support
> > reformatting it for easier reading, adding further APIs, splitting it
> > into five steps, and including references to the documentation in
> > dmaengine.h.
> > 
> > Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
> > ---
> >  Documentation/dmaengine.txt |  211 ++++++++++++++++++++++++++++++-------------
> >  1 files changed, 146 insertions(+), 65 deletions(-)
> > 
> > diff --git a/Documentation/dmaengine.txt b/Documentation/dmaengine.txt
> > index 5a0cb1e..8c2e888 100644
> > --- a/Documentation/dmaengine.txt
> > +++ b/Documentation/dmaengine.txt
> > @@ -10,87 +10,168 @@
> >  Below is a guide to device driver writers on how to use the Slave-DMA API of the
> >  DMA Engine. This is applicable only for slave DMA usage only.
> >  
> > -The slave DMA usage consists of following steps
> > +The slave DMA usage consists of following steps:
> >  1. Allocate a DMA slave channel
> >  2. Set slave and controller specific parameters
> >  3. Get a descriptor for transaction
> >  4. Submit the transaction and wait for callback notification
> > +5. Issue pending requests
> Thanks Russell,
> 
> Applied with change to 4 above. Moved "and wait for callback
> notification" to 5.

BTW, did you apply this one or the later one with the improved
documentation for dma mapping and fixed interface for slave
transfers etc. ?