[PATCH v9 1/3] MTD : add the common code for GPMI-NAND controller driver

[marek.vasut@gmail.com (Marek Vasut)]

On Monday, August 22, 2011 08:45:01 AM Huang Shijie wrote:
> Hi Artem:
> > On Mon, 2011-08-22 at 12:34 +0800, Huang Shijie wrote:
> >>>> +	pr_info("ECC Algorithm          : %s\n", geo->ecc_algorithm);
> >>>> +	pr_info("ECC Strength           : %u\n", geo->ecc_strength);
> >>>> +	pr_info("Page Size in Bytes     : %u\n", geo->page_size_in_bytes);
> >>>> +	pr_info("Metadata Size in Bytes : %u\n",
> >>>> geo->metadata_size_in_bytes); +	pr_info("ECC Chunk Size in Bytes:
> >>>> %u\n", geo->ecc_chunk_size_in_bytes); +	pr_info("ECC Chunk Count     
> >>>>   : %u\n", geo->ecc_chunk_count); +	pr_info("Payload Size in Bytes  :
> >>>> %u\n", geo->payload_size_in_bytes); +	pr_info("Auxiliary Size in
> >>>> Bytes: %u\n", geo->auxiliary_size_in_bytes); +	pr_info("Auxiliary
> >>>> Status Offset: %u\n", geo->auxiliary_status_offset); +	pr_info("Block
> >>>> Mark Byte Offset : %u\n", geo->block_mark_byte_offset);
> >>>> +	pr_info("Block Mark Bit Offset  : %u\n",
> >>>> geo->block_mark_bit_offset); +}
> >>> 
> >>> Isn't it too much info for normal users? Should this be pr_debug()
> >> 
> >> the log is only printed out when the bug occurs.
> >> so it's not for normal users.
> >> 
> >>> instead? There is another similar place in your code.
> >> 
> >> ok, I will change to pr_debug().
> > 
> > I did not read the driver code carefully, so did not realize this is
> > printed only in case of a bug - I thought this is printed on every boot
> > up. For the bug case it may be OK to use pr_info as well, so I take back
> > by comment about using pr_debug(), apologies.
> 
> thank you all the same :)

If this is printed only in case of bug, I agree with Artem.

Sorry Huang, cheers!

> 
> Huang Shijie
> 
> 
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel