[PATCH 7/7] OMAP3: beagleboard: Remove DT support from regular board

[tony@atomide.com (Tony Lindgren)]

* Cousson, Benoit <b-cousson@ti.com> [110902 11:26]:
> On 9/2/2011 10:12 AM, Tony Lindgren wrote:
> >* Benoit Cousson<b-cousson@ti.com>  [110901 19:52]:
> >>In order to avoid conflict with the new board-omap3-dt.c file,
> >>remove the .dt_compat entry from the beagle regular board
> >>file.
> >>
> >>Any DT work for OMAP3 will have to be done on the generic DT
> >>board file to avoid breaking the legacy board support until
> >>DT migration is done.
> >
> >In general we should not keep duplicate old non-DT data around
> >now that we have the DT append support. Instead we should just
> >require the .dts file appended to zImage for all mach-omap2
> >machines. Otherwise we'll end up with double bloat :)
> 
> Mmm, I'm not sure to get your point. We are not duplicating, since a
> pure DT generic board will not have anything except a
> of_platform_populate(NULL, omap_dt_match_table, NULL, NULL);
> And the regular board files will keep initializing devices statically.
> The drivers will then for the moment support both pdata and DT
> method to get board parameters.

Well when converting a driver to DT, we should just drop pdata
support. No need to keep it around as it will just make it harder
for us to clean up afterwards.
 
> >So it's OK to have the DT entries in board files so drivers
> >that get converted will work with them.
> 
> Well, it will be a little bit more tricky, because having DT in
> current board files will be a mess with a bunch of #ifdef CONFIG_OF,
> and adding DT compatible inside each boards will prevent the pure
> generic DT one to work. In that case we will duplicate the DT
> migration in every legacy boards files...

We should just select CONFIG_OF deal with it that way.
 
> That's why the current strategy is to keep the current board files
> non-DT aware and add the DT support only to the generic DT board
> file.

Well I don't like that, it will be a big mess. We'll end up with
twice the amount of platform_data and init code. It's OK to
require CONFIG_OF as it's known to work with the append support
for older boards.

It's easier just to require DT append for all the boards. In most
cases it's just a trivial include of the common dts file for now.

When we convert something to DT, there's no point going back.

Regards,

Tony