From mboxrd@z Thu Jan  1 00:00:00 1970
From: jamie@jamieiles.com (Jamie Iles)
Date: Thu, 24 Nov 2011 22:28:36 +0000
Subject: [PATCH] at91_ether: use gpio_is_valid for phy IRQ line
In-Reply-To: <1322169674-4109-1-git-send-email-nicolas.ferre@atmel.com>
References: <1322128098-17724-1-git-send-email-jamie@jamieiles.com>
 <1322169674-4109-1-git-send-email-nicolas.ferre@atmel.com>
Message-ID: <20111124222836.GB28582@gallagher>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

Hi Nicolas,

On Thu, Nov 24, 2011 at 10:21:14PM +0100, Nicolas Ferre wrote:
> Use the generic gpiolib gpio_is_valid() function to test
> if the phy IRQ line GPIO is actually provided.
> 
> For non-connected or non-existing phy IRQ lines, -EINVAL
> value is used for phy_irq_pin field of struct at91_eth_data.
> 
> Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
> ---
>  drivers/net/ethernet/cadence/at91_ether.c |   23 +++++++++++++----------
>  1 files changed, 13 insertions(+), 10 deletions(-)
> 
> diff --git a/drivers/net/ethernet/cadence/at91_ether.c b/drivers/net/ethernet/cadence/at91_ether.c
> index 56624d3..a1c4143 100644
> --- a/drivers/net/ethernet/cadence/at91_ether.c
> +++ b/drivers/net/ethernet/cadence/at91_ether.c
> @@ -255,8 +255,7 @@ static void enable_phyirq(struct net_device *dev)
>  	unsigned int dsintr, irq_number;
>  	int status;
>  
> -	irq_number = lp->board_data.phy_irq_pin;
> -	if (!irq_number) {
> +	if (!gpio_is_valid(lp->board_data.phy_irq_pin)) {
>  		/*
>  		 * PHY doesn't have an IRQ pin (RTL8201, DP83847, AC101L),
>  		 * or board does not have it connected.
> @@ -265,6 +264,7 @@ static void enable_phyirq(struct net_device *dev)
>  		return;
>  	}
>  
> +	irq_number = lp->board_data.phy_irq_pin;

Does this need to be:

	irq_number = gpio_to_irq(lp->board_data.phy_irq_pin);

and the same for the other occurrences?  Otherwise this looks like the 
right thing to me.

Jamie