From mboxrd@z Thu Jan  1 00:00:00 1970
From: shawn.guo@linaro.org (Shawn Guo)
Date: Wed, 14 Mar 2012 13:41:20 +0800
Subject: [PATCH v1 1/5] ARM: imx28: add basic dt support
In-Reply-To: <20120313172351.97C5E3E053B@localhost>
References: <1331628428-24017-1-git-send-email-b29396@freescale.com>
 <1331628428-24017-2-git-send-email-b29396@freescale.com>
 <20120313172351.97C5E3E053B@localhost>
Message-ID: <20120314054116.GD21337@S2101-09.ap.freescale.net>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

On Tue, Mar 13, 2012 at 11:23:51AM -0600, Grant Likely wrote:
...
> > +	apb at 80000000 {
> > +		compatible = "simple-bus";
> > +		#address-cells = <1>;
> > +		#size-cells = <1>;
> > +		reg = <0x80000000 0x80000>;
> > +		ranges;
> > +
> > +		apbh at 80000000 {
> > +			compatible = "simple-bus";
> > +			#address-cells = <1>;
> > +			#size-cells = <1>;
> > +			reg = <0x80000000 0x3c900>;
> > +			ranges;
> > +
> > +			icoll: interrupt-controller at 80000000 {
> > +				compatible = "fsl,imx28-icoll";
> > +				interrupt-controller;
> > +				#interrupt-cells = <1>;
> > +				reg = <0x80000000 0x2000>;
> > +			};
> > +		};
> > +
> > +		apbx at 80040000 {
> > +			compatible = "simple-bus";
> > +			#address-cells = <1>;
> > +			#size-cells = <1>;
> > +			reg = <0x80040000 0x40000>;
> > +			ranges;
> > +
> > +			uart1: uart at 80074000 {
> > +				compatible = "arm,pl011", "arm,primecell";
> > +				reg = <0x80074000 0x2000>;
> > +				interrupts = <47>;
> > +			};
> > +		};
> 
> What is the purpose of the apbh and apbx busses?  Will more device nodes
> get added to them later, or does each only contain a single device?
> 
Since our ultimate goal is to convert mach-mxs over to device tree,
I would also suggest we have all the hardware blocks defined in dts
from the beginning.

-- 
Regards,
Shawn