[PATCH 05/19] ARM: OMAP4: PM: Add SAR backup support towards device OFF

[tony@atomide.com (Tony Lindgren)]

* Tero Kristo <t-kristo@ti.com> [120420 02:39]:
> +
> +static int omap4_sar_not_accessible(void)
> +{
> +	u32 usbhost_state, usbtll_state;
> +
> +	/*
> +	 * Make sure that USB host and TLL modules are not
> +	 * enabled before attempting to save the context
> +	 * registers, otherwise this will trigger an exception.
> +	 */
> +	usbhost_state = omap4_cminst_read_inst_reg(OMAP4430_CM2_PARTITION,
> +						   OMAP4430_CM2_L3INIT_INST,
> +						   OMAP4_CM_L3INIT_USB_HOST_CLKCTRL_OFFSET)
> +	    & (OMAP4430_STBYST_MASK | OMAP4430_IDLEST_MASK);
> +
> +	usbtll_state = omap4_cminst_read_inst_reg(OMAP4430_CM2_PARTITION,
> +						  OMAP4430_CM2_L3INIT_INST,
> +						  OMAP4_CM_L3INIT_USB_TLL_CLKCTRL_OFFSET)
> +	    & OMAP4430_IDLEST_MASK;

Formatting here looks bad, maybe just do it in separate steps:

	usbhost_state = omap4_cminst...
	usbhost_state &= OMAP4430_STBYST_MASK | OMAP4430_IDLEST_MASK;
...


> +	/*
> +	 * Not supported on ES1.0 silicon
> +	 */
> +	if (omap_rev() == OMAP4430_REV_ES1_0) {
> +		WARN_ONCE(1, "omap4: SAR backup not supported on ES1.0 ..\n");
> +		return -ENODEV;
> +	}

Everytime there's SoC/hardware revision detection in a non __init function, 
something is most likely wrong.


> +void omap4_sar_overwrite(void)
> +{
> +	u32 val = 0;
> +	u32 offset = 0;
> +
> +	if (cpu_is_omap446x())
> +		offset = 0x04;

Here too.


> +static int __init omap4_sar_ram_init(void)
> +{
> +	/*
> +	 * To avoid code running on other OMAPs in
> +	 * multi-omap builds
> +	 */
> +	if (!cpu_is_omap44xx())
> +		return -ENODEV;

You should configure things here instead by setting function
pointers or variables.

Regards,

Tony