[PATCH 01/10] mmc: mxs-mmc: use global stmp_device functionality

[marex@denx.de (Marek Vasut)]

Dear Shawn Guo,

> Use global stmp_device functionality to reduce mach-dependency.
> 
> Signed-off-by: Shawn Guo <shawn.guo@linaro.org>

Acked-by: Marek Vasut <marex@denx.de>

> ---
>  drivers/mmc/host/mxs-mmc.c |   14 +++++++-------
>  1 files changed, 7 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/mmc/host/mxs-mmc.c b/drivers/mmc/host/mxs-mmc.c
> index bb03ddd..2ea5361 100644
> --- a/drivers/mmc/host/mxs-mmc.c
> +++ b/drivers/mmc/host/mxs-mmc.c
> @@ -40,9 +40,9 @@
>  #include <linux/module.h>
>  #include <linux/fsl/mxs-dma.h>
>  #include <linux/pinctrl/consumer.h>
> +#include <linux/stmp_device.h>
> 
>  #include <mach/mxs.h>
> -#include <mach/common.h>
>  #include <mach/mmc.h>
> 
>  #define DRIVER_NAME	"mxs-mmc"
> @@ -191,7 +191,7 @@ static void mxs_mmc_reset(struct mxs_mmc_host *host)
>  {
>  	u32 ctrl0, ctrl1;
> 
> -	mxs_reset_block(host->base);
> +	stmp_reset_block(host->base);
> 
>  	ctrl0 = BM_SSP_CTRL0_IGNORE_CRC;
>  	ctrl1 = BF_SSP(0x3, CTRL1_SSP_MODE) |
> @@ -279,7 +279,7 @@ static irqreturn_t mxs_mmc_irq_handler(int irq, void
> *dev_id)
> 
>  	stat = readl(host->base + HW_SSP_CTRL1);
>  	writel(stat & MXS_MMC_IRQ_BITS,
> -	       host->base + HW_SSP_CTRL1 + MXS_CLR_ADDR);
> +	       host->base + HW_SSP_CTRL1 + STMP_OFFSET_REG_CLR);
> 
>  	if ((stat & BM_SSP_CTRL1_SDIO_IRQ) && (stat & BM_SSP_CTRL1_SDIO_IRQ_EN))
>  		mmc_signal_sdio_irq(host->mmc);
> @@ -637,18 +637,18 @@ static void mxs_mmc_enable_sdio_irq(struct mmc_host
> *mmc, int enable)
> 
>  	if (enable) {
>  		writel(BM_SSP_CTRL0_SDIO_IRQ_CHECK,
> -		       host->base + HW_SSP_CTRL0 + MXS_SET_ADDR);
> +		       host->base + HW_SSP_CTRL0 + STMP_OFFSET_REG_SET);
>  		writel(BM_SSP_CTRL1_SDIO_IRQ_EN,
> -		       host->base + HW_SSP_CTRL1 + MXS_SET_ADDR);
> +		       host->base + HW_SSP_CTRL1 + STMP_OFFSET_REG_SET);
> 
>  		if (readl(host->base + HW_SSP_STATUS) & BM_SSP_STATUS_SDIO_IRQ)
>  			mmc_signal_sdio_irq(host->mmc);
> 
>  	} else {
>  		writel(BM_SSP_CTRL0_SDIO_IRQ_CHECK,
> -		       host->base + HW_SSP_CTRL0 + MXS_CLR_ADDR);
> +		       host->base + HW_SSP_CTRL0 + STMP_OFFSET_REG_CLR);
>  		writel(BM_SSP_CTRL1_SDIO_IRQ_EN,
> -		       host->base + HW_SSP_CTRL1 + MXS_CLR_ADDR);
> +		       host->base + HW_SSP_CTRL1 + STMP_OFFSET_REG_CLR);
>  	}
> 
>  	spin_unlock_irqrestore(&host->lock, flags);

Best regards,
Marek Vasut