From mboxrd@z Thu Jan 1 00:00:00 1970 From: thomas.petazzoni@free-electrons.com (Thomas Petazzoni) Date: Fri, 15 Jun 2012 14:53:41 +0200 Subject: Converting kirkwood-goflexnet to DTS In-Reply-To: References: <20120614141706.GA6676@lunn.ch> <20120615104140.24bf25f3@skate> Message-ID: <20120615145341.1b40f84a@skate> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Josh, Le Fri, 15 Jun 2012 08:40:48 -0400, Josh Coombs a ?crit : > You were both correct. After one additional test failure last night > and a lot more reading I reached the same conclusion, I was foolishly > thinking .dtbs would be automatically appended to the kernel when > configured to support that method of including them. Yeah, but the DTB append feature is only a development/debugging feature provided to allow DT-related development with non-DT capable bootloaders. However, my understanding is that it is assumed that people should ultimately use DT-capable bootloaders. > That resulted in: http://pastie.org/4092019 > > Boots, with some serious errors, doesn't seem to mount a FS and stops. > Reducing my kernel arguments down to "console=ttyS0,115200 > earlyprintk rootfs=/dev/sda1 rootdelay=10" I see the same errors, but > I also show the key hardware involved being detected, and the nand > partitioning looks correct. My status LED goes solid green, so it > appears something is working right. I'll dig into goflexnet_init next > to try and determine what is wrong in there. Haven't looked at the details, but aren't certain devices registered multiple times? Thomas -- Thomas Petazzoni, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com