[PATCH v3] ARM: OMAP3: USB: Fix the EHCI ULPI PHY reset fix issues.

[sameo@linux.intel.com (Samuel Ortiz)]

Hi Russ,

On Thu, Jun 14, 2012 at 09:24:21AM -0700, Russ Dill wrote:
> From: Russ Dill <Russ.Dill@gmail.com>
> 
> 'ARM: OMAP3: USB: Fix the EHCI ULPI PHY reset issue' (1fcb57d0) fixes
> an issue where the ULPI PHYs were not held in reset while initializing
> the EHCI controller. However, it also changes behavior in
> omap-usb-host.c omap_usbhs_init by releasing reset while the
> configuration in that function was done.
> 
> This change caused a regression on BB-xM where USB would not function
> if 'usb start' had been run from u-boot before booting. A change was
> made to release reset a little bit earlier which fixed the issue on
> BB-xM and did not cause any regressions on 3430 sdp, the board for
> which the fix was originally made.
> 
> This new fix, 'USB: EHCI: OMAP: Finish ehci omap phy reset cycle
> before adding hcd.', (3aa2ae74) caused a regression on OMAP5.
> 
> The original fix to hold the EHCI controller in reset during
> initialization was correct, however it appears that changing
> omap_usbhs_init to not hold the PHYs in reset during it's
> configuration was incorrect. This patch first reverts both fixes, and
> then changes ehci_hcd_omap_probe in ehci-omap.c to hold the PHYs in
> reset as the original patch had done. It also is sure to incorporate
> the _cansleep change that has been made in the meantime.
> 
> I've tested this on Beagleboard xM, I'd really like to get an ack from
> the 3430 sdp and OMAP5 guys before getting this merged.
> 
> v3 - Brown paper bag its too early in the morning actually run
>      git commit amend fix
> v2 - Put cansleep gpiolib call outside of spinlock
> 
> Signed-off-by: Russ Dill <Russ.Dill@gmail.com>
> ---
>  drivers/mfd/omap-usb-host.c  |   48 +++++++++++++++++++++++++++++++++++++++++-
>  drivers/usb/host/ehci-omap.c |   18 +++++++---------
>  2 files changed, 55 insertions(+), 11 deletions(-)
I applied this one to my for-linus branch, it will be part of my next 3.5 pull
request to Linus.

Cheers,
Samuel.

-- 
Intel Open Source Technology Centre
http://oss.intel.com/