[PATCH-V3 1/3] ARM: OMAP2+: CLEANUP: All OMAP2PLUS uses omap-device.o target so add one entry

[tony@atomide.com (Tony Lindgren)]

Hi

Applying these, but few comments below to make my life easier..

* Vaibhav Hiremath <hvaibhav@ti.com> [120628 08:04]:
> All OMAP2PLUS based devices, builds omap-device.o target;
> so just add one entry so that there is no need to patch this file
> for any future OMAP2+ devices.
> 
> Signed-off-by: Vaibhav Hiremath <hvaibhav@ti.com>
> Cc: Tony Lindgren <tony@atomide.com>
> Cc: Kevin Hilman <khilman@ti.com>
> Cc: Paul Walmsley <paul@pwsan.com>
> 
> NOTE: No code change from last version.

Extra comments like this should be within the --- sections so they
down't show up when applying the patch. Otherwise I have to manually
edit every patch, which sucks.

Then, I'm leaving out the CLEANUP part in $Subject, that alone is not
a reason to patch anything. The description should say why the patch
is needed, which it does. If you want to specify that this should be
grouped in the clean-up branch, then that too could be mentioned within
the --- sections.

> ---
>  arch/arm/plat-omap/Makefile |    4 +---
>  1 files changed, 1 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm/plat-omap/Makefile b/arch/arm/plat-omap/Makefile
> index 6d87532..961bf85 100644
> --- a/arch/arm/plat-omap/Makefile
> +++ b/arch/arm/plat-omap/Makefile
> @@ -10,9 +10,7 @@ obj-n :=
>  obj-  :=
> 
>  # omap_device support (OMAP2+ only at the moment)
> -obj-$(CONFIG_ARCH_OMAP2) += omap_device.o
> -obj-$(CONFIG_ARCH_OMAP3) += omap_device.o
> -obj-$(CONFIG_ARCH_OMAP4) += omap_device.o
> +obj-$(CONFIG_ARCH_OMAP2PLUS) += omap_device.o
> 
>  obj-$(CONFIG_OMAP_DM_TIMER) += dmtimer.o
>  obj-$(CONFIG_OMAP_DEBUG_DEVICES) += debug-devices.o
> --
> 1.7.0.4
> 

This patch did not apply for some reason, I got:

patching file arch/arm/plat-omap/Makefile
patch: **** malformed patch at line 73: 1.7.0.4

So please tune up your scripts a bit to the patches can be applied
as they are without manual editing ;)

Thanks,

Tony