[U-Boot] Where to put a large bootloader-supplied device tree on ARM ?

[wd@denx.de (Wolfgang Denk)]

Dear Albert ARIBAUD,

In message <20120712233801.0411daa7@lilith> you wrote:
> 
> If I'm not mistaken, yes U-Boot loads itself as high as it can, and I don't
> know about the FDT, but no, U-Boot does not "like" to load initrd "just
> below that": it loads initrd where the boot commands tell it to, and the
> boot commands are written by board developers. Nothing in U-Boot forces
> initrd to be loaded as high as possible.
> 
> That leaves the question of the FDT, though -- I'm not familiar enough
> with it (yet) to tell if it is always located just under U-Boot or if
> its placement is controllable by board commands.

You can always just set the "fdt_high" and "initrd_high" evironment
variables to restrict the positioning of initrd and FDT in RAM; see
the README for details.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"He was so narrow minded he could see through  a  keyhole  with  both
eyes ..."