From mboxrd@z Thu Jan 1 00:00:00 1970 From: tony@atomide.com (Tony Lindgren) Date: Thu, 6 Sep 2012 13:58:12 -0700 Subject: [PATCH v6 2/3] arm/dts: AM33XX: Configure pinmuxs for user leds control on Bone In-Reply-To: <1346845260-10978-3-git-send-email-anilkumar@ti.com> References: <1346845260-10978-1-git-send-email-anilkumar@ti.com> <1346845260-10978-3-git-send-email-anilkumar@ti.com> Message-ID: <20120906205811.GO1303@atomide.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org * AnilKumar Ch [120905 04:42]: > Adds GPIO pinctrl nodes to am3358_pinmux master node to control > user leds (USR0, USR1, USR2 and USR3) present on BeagleBone. > > [koen at dominion.thruhere.net: led0, led1 suggested by koen] > Signed-off-by: AnilKumar Ch > --- > arch/arm/boot/dts/am335x-bone.dts | 43 +++++++++++++++++++++++++++++++++++++ > 1 file changed, 43 insertions(+) > > diff --git a/arch/arm/boot/dts/am335x-bone.dts b/arch/arm/boot/dts/am335x-bone.dts > index c634f87..822efe6 100644 > --- a/arch/arm/boot/dts/am335x-bone.dts > +++ b/arch/arm/boot/dts/am335x-bone.dts > @@ -18,11 +18,54 @@ > reg = <0x80000000 0x10000000>; /* 256 MB */ > }; > > + am3358_pinmux: pinmux at 44e10800 { > + userled_pins: pinmux_userled_pins { > + pinctrl-single,pins = < > + 0x54 0x7 /* gpmc_a5.gpio1_21, OUTPUT | MODE7 */ > + 0x58 0x17 /* gpmc_a6.gpio1_22, OUTPUT_PULLUP | MODE7 */ > + 0x5c 0x7 /* gpmc_a7.gpio1_23, OUTPUT | MODE7 */ > + 0x60 0x17 /* gpmc_a8.gpio1_24, OUTPUT_PULLUP | MODE7 */ > + >; > + }; > + }; > + Just checking.. am3358_pinmux should be am33xx_pinmux in this patch too as discussed. Regards, Tony