[PATCH 08/10] ARM: OMAP: Clean-up timer posted mode support

[tony@atomide.com (Tony Lindgren)]

* Jon Hunter <jon-hunter@ti.com> [120910 15:00]:
> 
> On 09/07/2012 05:22 PM, Tony Lindgren wrote:
> > * Jon Hunter <jon-hunter@ti.com> [120905 12:05]:
> >> The dmtimer functions to read and write the dmtimer registers are currently
> >> defined as follows ...
> >>
> >> static inline u32 __omap_dm_timer_read(struct omap_dm_timer *timer, u32 reg,
> >> 						int posted);
> >> static inline void __omap_dm_timer_write(struct omap_dm_timer *timer,
> >> 						u32 reg, u32 val, int posted);
> >>
> >> The posted variable indicates if the timer is configured to use the posted mode
> >> when performing register accesses. The posted mode configuration of the dmtimer
> >> is stored in the omap_dm_timer structure that is also being passed to the above
> >> functions and therefore we do not need to pass the posted variable separately.
> >> Therefore, simplify the above functions by removing the posted variable as an
> >> argument as this is not necessary.
> > 
> > I believe the reason for passing the posted flag was to optimize out some
> > functions from the timer code as that's being run all the time.
> > 
> > Care to check the assembly before and after this patch for the timer
> > functions with objdump -d to make sure it does not add tons of bloat
> > there?
> 
> Hi Tony,
> 
> Thanks for the details here. I see that makes sense and that the
> compiler could take advantage of this as the functions are inlined.
> 
> I have taken a look at the disassembled output using objdump as you
> mentioned. What I see is ...
> 
> 1. For dmtimer.c the impact appears negligible, the total number of
>    lines outputted by objdump only changed by 8 with (1215 lines) and
>    without (1207 lines) the patch applied.
> 
> 2. For timer.c the impact is greater. I see that
>    omap2_gp_timer_set_next_event() increased by 6 instructions from 29
>    to 35. clocksource_read_cycles() increased by 2 instructions 15 to
>    17 instructions. dmtimer_read_sched_clock() increased by 2
>    instructions from 17 to 19. omap2_gp_timer_set_mode() increased by
>    21 instructions from 102 to 123.
> 
> I imagine that we are mainly concerned about
> omap2_gp_timer_set_next_event(), clocksource_read_cycles() and
> dmtimer_read_sched_clock() as these will be called often. Therefore, I
> am not sure if you wish to drop this patch.

Well does it at lots of new ldr to the critical code?
 
> By the way, if we do drop this patch, I would then need to fix the
> setting of the posted variable in mach-omap2/timer.c for clock-source in
> the case where a dmtimer is used. Today the code assumes that for
> clock-source and clock-events posted mode is always used. However, with
> the errata i103/i767 we will disable posted mode for clock-source on
> omap2/3/4/5/am33xx devices.

Yes I see, I guess that means just adding a new systimer entry?

Regards,

Tony