[PATCH 1/2] spi: omap2-mcspi: add pinctrl support

[tony@atomide.com (Tony Lindgren)]

* Matt Porter <mporter@ti.com> [120911 10:46]:
> Adds pinctrl support to support OMAP platforms that boot from DT
> and rely on pinctrl support to set pinmuxes.
> 
> Signed-off-by: Matt Porter <mporter@ti.com>
> ---
>  drivers/spi/spi-omap2-mcspi.c |    9 +++++++++
>  1 file changed, 9 insertions(+)
> 
> diff --git a/drivers/spi/spi-omap2-mcspi.c b/drivers/spi/spi-omap2-mcspi.c
> index b2fb141..6c67cdb 100644
> --- a/drivers/spi/spi-omap2-mcspi.c
> +++ b/drivers/spi/spi-omap2-mcspi.c
> @@ -38,6 +38,8 @@
>  #include <linux/pm_runtime.h>
>  #include <linux/of.h>
>  #include <linux/of_device.h>
> +#include <linux/pinctrl/consumer.h>
> +#include <linux/err.h>
>  
>  #include <linux/spi/spi.h>
>  
> @@ -1124,6 +1126,7 @@ static int __devinit omap2_mcspi_probe(struct platform_device *pdev)
>  	static int		bus_num = 1;
>  	struct device_node	*node = pdev->dev.of_node;
>  	const struct of_device_id *match;
> +	struct pinctrl *pinctrl;
>  
>  	master = spi_alloc_master(&pdev->dev, sizeof *mcspi);
>  	if (master == NULL) {
> @@ -1219,6 +1222,12 @@ static int __devinit omap2_mcspi_probe(struct platform_device *pdev)
>  	if (status < 0)
>  		goto dma_chnl_free;
>  
> +	pinctrl = devm_pinctrl_get_select_default(&pdev->dev);
> +	if (IS_ERR(pinctrl)) {
> +		status = PTR_ERR(pinctrl);
> +		goto dma_chnl_free;
> +	}
> +
>  	pm_runtime_use_autosuspend(&pdev->dev);
>  	pm_runtime_set_autosuspend_delay(&pdev->dev, SPI_AUTOSUSPEND_TIMEOUT);
>  	pm_runtime_enable(&pdev->dev);

You should just print out a warning here as most boards don't
have pinctrl implemented at this point, or may never have.

Regards,

Tony