From mboxrd@z Thu Jan 1 00:00:00 1970 From: tony@atomide.com (Tony Lindgren) Date: Thu, 20 Sep 2012 15:16:31 -0700 Subject: [RFC PATCH 07/13] mmc: omap_hsmmc: dma_request_slave_channel() support for DT platforms In-Reply-To: <1348152226-13588-8-git-send-email-mporter@ti.com> References: <1348152226-13588-1-git-send-email-mporter@ti.com> <1348152226-13588-8-git-send-email-mporter@ti.com> Message-ID: <20120920221630.GL28835@atomide.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org * Matt Porter [120920 07:43]: > For platforms with DT populated, use dma_request_slave_channel() > to acquire the DMA channel. For !DT platforms, we fall back to > explicitly passing the omap_dma_filter_fn() to dma_request_channel(). > Once all platforms boot from DT, the dma_request_channel() path can > be dropped. > > Signed-off-by: Matt Porter > --- > drivers/mmc/host/omap_hsmmc.c | 16 ++++++++++++++-- > 1 file changed, 14 insertions(+), 2 deletions(-) > > diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c > index 3a09f93..c82d0ab 100644 > --- a/drivers/mmc/host/omap_hsmmc.c > +++ b/drivers/mmc/host/omap_hsmmc.c > @@ -1923,14 +1923,26 @@ static int __devinit omap_hsmmc_probe(struct platform_device *pdev) > dma_cap_zero(mask); > dma_cap_set(DMA_SLAVE, mask); > > - host->rx_chan = dma_request_channel(mask, omap_dma_filter_fn, &rx_req); > + if (pdev->dev.of_node) > + host->rx_chan = > + dma_request_slave_channel(&pdev->dev, "rx"); > + else > + host->rx_chan = dma_request_channel(mask, > + omap_dma_filter_fn, > + &rx_req); > if (!host->rx_chan) { > dev_err(mmc_dev(host->mmc), "unable to obtain RX DMA engine channel %u\n", rx_req); > ret = -ENXIO; > goto err_irq; > } > > - host->tx_chan = dma_request_channel(mask, omap_dma_filter_fn, &tx_req); > + if (pdev->dev.of_node) > + host->tx_chan = > + dma_request_slave_channel(&pdev->dev, "tx"); > + else > + host->tx_chan = dma_request_channel(mask, > + omap_dma_filter_fn, > + &tx_req); > if (!host->tx_chan) { > dev_err(mmc_dev(host->mmc), "unable to obtain TX DMA engine channel %u\n", tx_req); > ret = -ENXIO; > Here to the omap_hsmmc.c driver should not need to care about which way to request the dma channels. Regards, Tony