[GIT PULL] ARM: OMAP: warnings/hwmod/clock fixes for pre-3.7-rc1

[tony@atomide.com (Tony Lindgren)]

* Paul Walmsley <paul@pwsan.com> [121009 12:31]:
> On Tue, 9 Oct 2012, Tony Lindgren wrote:
> 
> > * Paul Walmsley <paul@pwsan.com> [121009 09:05]:
> > > 
> > > N800 isn't booting; this is a problem present in the base commit and
> > > is due to serial driver breakage:
> > > 
> > >    http://www.spinics.net/lists/arm-kernel/msg196034.html
> > 
> > This might be related also to the n800 booting in sys mode
> > that causes issues with the recent hyp patches. A fix for
> > that has been queued, for more info see the thread
> > "v2 2/7] ARM: virt: allow the kernel to be entered in HYP mode".
> 
> Thanks for the pointer.  That one would break the boot quite early, right? 
> This one has the same symptoms as the serial issue, where it bombs out 
> after:
> 
> [    0.948394] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
> [    0.974273] omap_uart.0: ttyO0 at MMIO 0x4806a000 (irq = 88) is a OMAP UART0
> [    0.986968] omap_uart.1: ttyO1 at MMIO 0x4806c000 (irq = 89) is a OMAP UART1
> 
> (hang)

Yes the sys mode hangs right away and only prints a few lines
with earlyprintk.

Regards,

Tony