From mboxrd@z Thu Jan 1 00:00:00 1970 From: mporter@ti.com (Matt Porter) Date: Wed, 10 Oct 2012 10:35:01 -0400 Subject: [PATCH] ARM: OMAP2+: gpmc: Fix kernel BUG for DT boot mode In-Reply-To: <79CD15C6BA57404B839C016229A409A83EB3B573@DBDE01.ent.ti.com> References: <1349773040-8204-1-git-send-email-hvaibhav@ti.com> <20121010140027.GB13724@beef> <79CD15C6BA57404B839C016229A409A83EB3B573@DBDE01.ent.ti.com> Message-ID: <20121010143501.GC13724@beef> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Oct 10, 2012 at 02:19:40PM +0000, Vaibhav Hiremath wrote: > On Wed, Oct 10, 2012 at 19:30:27, Porter, Matt wrote: > > On Tue, Oct 09, 2012 at 02:27:20PM +0530, Vaibhav Hiremath wrote: > > > With recent changes in omap gpmc driver code, in case of DT > > > boot mode, where bootloader does not configure gpmc cs space > > > will result into kernel BUG() inside gpmc_mem_init() function, > > > as gpmc cs0 gpmc_config7[0].csvalid bit is set to '1' and > > > gpmc_config7[0].baseaddress is set to '0' on reset. > > > > > > This use-case is applicable for any board/EVM which doesn't have > > > any peripheral connected to gpmc cs0, for example BeagleXM and > > > BeagleBone, so DT boot mode fails. > > > > > > This patch adds of_have_populated_dt() check before creating > > > device, so that for DT boot mode, gpmc probe will not be called > > > which is expected behavior, as gpmc is not supported yet from DT. > > > > > > Signed-off-by: Vaibhav Hiremath > > > Cc: Afzal Mohammed > > > Cc: Tony Lindgren > > > Cc Paul Walmsley > > > --- > > > This should go in for rc1, as this breaks AM33xx boot. > > > > Fixes BeagleBone on mainline. > > > > Tested-by: Matt Porter > > > > Thanks Matt and Afzal, > > Tony can this be picked up for rc1?? I know you have already sent pull > request for rc1, but by any chance you are planning to send another request? I also found a separate problem with the mcasp clock data that's needed for rc1. I just posted a patch for that as I need both this patch and the clock data fix to boot from current mainline. -Matt