Fwd: [PATCH 2/5] ARM: OMAP3+: hwmod: Add AM33XX HWMOD data for davinci_mdio

[mporter@ti.com (Matt Porter)]

On Fri, Oct 19, 2012 at 09:00:41AM -0700, Tony Lindgren wrote:
> * Richard Cochran <richardcochran@gmail.com> [121018 23:18]:
> > On Fri, Oct 19, 2012 at 02:18:29AM +0530, Vaibhav Hiremath wrote:
> > > 
> > > Another important point is, this driver is also required and used for
> > > Davinci family of devices (arch/mach/mach-davinci/).
> > 
> > That is really beside the point. If the code isn't ready yet, then
> > don't merge it.
> > 
> > When I asked about the beaglebone, I was given the impression that it
> > will be ready for v3.7-rc1.  But, as I know realize, at the current
> > rate, it might not even be ready for v3.8.
> > 
> > I don't mind waiting, but please make sure that whatever lands into a
> > release is really, truly working.
> 
> Indeed. This has been a problem with many of the TI patches in
> general. People are working on separate product trees and then produce
> patches for the mainline kernel that are poorly tested.
> 
> The requirement should be: Do your patch on an omap board then send the
> patch from your omap board after booting your board with the patch :)

s/should be/is/

I fixed that for you. :) That's always been the requirement for the
kernel, period. There's also a lot of dead/unused code in the davinci
driver world too...so omap isn't alone with this phenomenon.

-Matt