From: will.deacon@arm.com (Will Deacon)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v4 14/14] KVM: ARM: Handle I/O aborts
Date: Mon, 19 Nov 2012 15:09:24 +0000 [thread overview]
Message-ID: <20121119150924.GF3205@mudshark.cambridge.arm.com> (raw)
In-Reply-To: <20121110154348.2836.45008.stgit@chazy-air>
On Sat, Nov 10, 2012 at 03:43:49PM +0000, Christoffer Dall wrote:
> When the guest accesses I/O memory this will create data abort
> exceptions and they are handled by decoding the HSR information
> (physical address, read/write, length, register) and forwarding reads
> and writes to QEMU which performs the device emulation.
>
> Certain classes of load/store operations do not support the syndrome
> information provided in the HSR and we therefore must be able to fetch
> the offending instruction from guest memory and decode it manually.
>
> We only support instruction decoding for valid reasonable MMIO operations
> where trapping them do not provide sufficient information in the HSR (no
> 16-bit Thumb instructions provide register writeback that we care about).
>
> The following instruction types are NOT supported for MMIO operations
> despite the HSR not containing decode info:
> - any Load/Store multiple
> - any load/store exclusive
> - any load/store dual
> - anything with the PC as the dest register
>
> This requires changing the general flow somewhat since new calls to run
> the VCPU must check if there's a pending MMIO load and perform the write
> after userspace has made the data available.
>
> Rusty Russell fixed a horrible race pointed out by Ben Herrenschmidt:
> (1) Guest complicated mmio instruction traps.
> (2) The hardware doesn't tell us enough, so we need to read the actual
> instruction which was being exectuted.
> (3) KVM maps the instruction virtual address to a physical address.
> (4) The guest (SMP) swaps out that page, and fills it with something else.
> (5) We read the physical address, but now that's the wrong thing.
>
> Reviewed-by: Marcelo Tosatti <mtosatti@redhat.com>
> Signed-off-by: Rusty Russell <rusty.russell@linaro.org>
> Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
> Signed-off-by: Christoffer Dall <c.dall@virtualopensystems.com>
This is looking like the right sort of thing now, but I would like to
see an Acked-by from Dave [CC'd] for this patch.
I'll try and hit the vGIC code this week...
Thanks,
Will
next prev parent reply other threads:[~2012-11-19 15:09 UTC|newest]
Thread overview: 65+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-11-10 15:42 [PATCH v4 00/14] KVM/ARM Implementation Christoffer Dall
2012-11-10 15:42 ` [PATCH v4 01/14] ARM: Add page table and page defines needed by KVM Christoffer Dall
2012-11-19 14:14 ` Will Deacon
2012-11-29 15:57 ` Christoffer Dall
2012-11-30 11:46 ` Will Deacon
2012-11-30 15:54 ` Christoffer Dall
2012-11-10 15:42 ` [PATCH v4 02/14] ARM: Section based HYP idmap Christoffer Dall
2012-11-19 14:16 ` Will Deacon
2012-11-29 18:59 ` Christoffer Dall
2012-11-30 10:58 ` Will Deacon
2012-11-30 16:29 ` Christoffer Dall
2012-11-19 14:25 ` Rob Herring
2012-11-10 15:42 ` [PATCH v4 03/14] ARM: Factor out cpuid implementor and part number Christoffer Dall
2012-11-19 14:21 ` Will Deacon
2012-11-29 21:38 ` Christoffer Dall
2012-11-30 10:21 ` Will Deacon
2012-11-30 15:42 ` Christoffer Dall
2012-11-10 15:42 ` [PATCH v4 04/14] KVM: ARM: Initial skeleton to compile KVM support Christoffer Dall
2012-11-19 14:41 ` Will Deacon
2012-11-29 22:36 ` Christoffer Dall
2012-11-10 15:42 ` [PATCH v4 05/14] KVM: ARM: Hypervisor inititalization Christoffer Dall
2012-11-19 14:51 ` Will Deacon
2012-11-19 15:27 ` Cyril Chemparathy
2012-11-30 5:41 ` Christoffer Dall
2012-11-10 15:42 ` [PATCH v4 06/14] KVM: ARM: Memory virtualization setup Christoffer Dall
2012-11-19 14:53 ` Will Deacon
2012-11-19 15:05 ` Christoffer Dall
2012-11-10 15:42 ` [PATCH v4 07/14] KVM: ARM: Inject IRQs and FIQs from userspace Christoffer Dall
2012-11-19 14:55 ` Will Deacon
2012-11-19 15:04 ` Christoffer Dall
2012-11-19 15:26 ` Will Deacon
2012-11-19 16:09 ` Christoffer Dall
2012-11-19 16:21 ` Will Deacon
2012-11-30 6:13 ` Christoffer Dall
2012-11-10 15:43 ` [PATCH v4 08/14] KVM: ARM: World-switch implementation Christoffer Dall
2012-11-19 14:57 ` Will Deacon
2012-11-30 6:37 ` Christoffer Dall
2012-11-30 15:15 ` Will Deacon
2012-11-30 16:47 ` Christoffer Dall
2012-11-30 17:14 ` Will Deacon
2012-11-30 18:49 ` Christoffer Dall
2012-12-03 10:33 ` Marc Zyngier
2012-12-03 15:05 ` Christoffer Dall
2012-11-10 15:43 ` [PATCH v4 09/14] KVM: ARM: Emulation framework and CP15 emulation Christoffer Dall
2012-11-19 15:01 ` Will Deacon
2012-11-19 15:27 ` [kvmarm] " Peter Maydell
2012-11-20 2:18 ` Rusty Russell
2012-11-30 20:22 ` Christoffer Dall
2012-12-03 11:05 ` Will Deacon
2012-12-03 19:09 ` Christoffer Dall
2012-11-10 15:43 ` [PATCH v4 10/14] KVM: ARM: User space API for getting/setting co-proc registers Christoffer Dall
2012-11-19 15:02 ` Will Deacon
2012-11-30 6:42 ` Christoffer Dall
2012-11-10 15:43 ` [PATCH v4 11/14] KVM: ARM: Demux CCSIDR in the userspace API Christoffer Dall
2012-11-19 15:03 ` Will Deacon
2012-11-30 6:45 ` Christoffer Dall
2012-11-10 15:43 ` [PATCH v4 12/14] KVM: ARM: VFP userspace interface Christoffer Dall
2012-11-10 15:43 ` [PATCH v4 13/14] KVM: ARM: Handle guest faults in KVM Christoffer Dall
2012-11-19 15:07 ` Will Deacon
2012-11-30 21:40 ` Christoffer Dall
2012-12-03 13:06 ` Will Deacon
2012-12-03 15:02 ` Christoffer Dall
2012-11-10 15:43 ` [PATCH v4 14/14] KVM: ARM: Handle I/O aborts Christoffer Dall
2012-11-19 15:09 ` Will Deacon [this message]
2012-11-30 14:46 ` Dave Martin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20121119150924.GF3205@mudshark.cambridge.arm.com \
--to=will.deacon@arm.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).