[PATCH 1/1] spi/atmel: add DT support

[grant.likely@secretlab.ca (Grant Likely)]

On Mon, 17 Dec 2012 11:13:51 +0100, Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com> wrote:
> On 01:03 Sat 15 Dec     , Grant Likely wrote:
> > On Wed, 12 Dec 2012 16:13:08 +0100, Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com> wrote:
> > > On 14:37 Fri 23 Nov     , Nicolas Ferre wrote:
> > > > On 11/23/2012 01:44 PM, Jean-Christophe PLAGNIOL-VILLARD :
> > > > > the atmel_spi use only gpio for chip select
> > > > > 
> > > > > Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
> > > > 
> > > > Seems simple and nice:
> > > > 
> > > > Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
> > > grant is ok to have this for 3.8?
> > 
> > Not sure how I missed this one. It's pretty straight forward and not
> > risky, so no problem. However;
> > 
> > > > > the atmel_spi use only gpio for chip select
> > 
> > I know you know how to write a proper commit message. I'll need
> > something better than the above before I commit it. I won't make you
> > resubmit the patch, but do send me a better description.
> > 
> ok replace with this please
> 
> spi/atmel: add DT support
> 
> Use the newly introduce cs-gpios dt support on atmel.
> We do not use the hardware cs as it's wired and have buges and limitations.
> As the the controller's belief that only active-low devices/systems exists.
> 
> As done on non-dt system.

Done, thanks.

g.