[PATCH] ARM: Kirkwood: convert ns2 boards to pinctrl

[andrew@lunn.ch (Andrew Lunn)]

On Tue, Jan 08, 2013 at 03:36:18PM +0100, Simon Guinot wrote:
> Note that the pinctrl conversion also fixes GPIO support for ns2 boards.
> Since commit f9e75922: "ARM: Kirkwood: Make use of mvebu pincltl and
> gpio", the mvbu_gpio driver is used for DT boards. As mvbu_gpio relies
> on the pinctrl driver, then a pinctrl definition must be given to allow
> the GPIO configuration.
> 
> Signed-off-by: Simon Guinot <simon.guinot@sequanux.org>
> ---
>  arch/arm/boot/dts/kirkwood-ns2-common.dtsi |   16 ++++++++++++
>  arch/arm/mach-kirkwood/board-ns2.c         |   38 ----------------------------
>  2 files changed, 16 insertions(+), 38 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/kirkwood-ns2-common.dtsi b/arch/arm/boot/dts/kirkwood-ns2-common.dtsi
> index 9bc6785..77d21ab 100644
> --- a/arch/arm/boot/dts/kirkwood-ns2-common.dtsi
> +++ b/arch/arm/boot/dts/kirkwood-ns2-common.dtsi
> @@ -1,4 +1,5 @@
>  /include/ "kirkwood.dtsi"
> +/include/ "kirkwood-6281.dtsi"
>  
>  / {
>  	chosen {
> @@ -6,6 +7,21 @@
>  	};
>  
>  	ocp at f1000000 {
> +		pinctrl: pinctrl at 10000 {
> +			pinctrl-0 = < &pmx_spi &pmx_twsi0 &pmx_uart0
> +					&pmx_ns2_sata0 &pmx_ns2_sata1>;
> +			pinctrl-names = "default";
> +
> +			pmx_ns2_sata0: pmx-ns2-sata0 {
> +				marvell,pins = "mpp21";
> +				marvell,function = "sata0";
> +			};
> +			pmx_ns2_sata1: pmx-ns2-sata1 {
> +				marvell,pins = "mpp20";
> +				marvell,function = "sata1";
> +			};
> +		};

Hi Simon

Its normal to also list all the gpio pins here as well. 

    Andrew