[U-Boot] [RFC] Kbuild support for ARM FIT images

[wd@denx.de (Wolfgang Denk)]

Dear Jason,

In message <20130221232821.GA2823@obsidianresearch.com> you wrote:
> 
> > > own seems to be rather static and stable, and unlike software there is 
> > > no way I can change it (soldering irons don't count).
> > 
> > There is other hardware available (for example FPGA based) where this
> > does not apply.
> 
> Agreed.. We do that here as well, the DT is also used to describe the
> functionality inside FPGA(s). We do things like declare a GPIO
> controller inside the FPGA, then stack the bitbang MDIO/I2C on top of
> that, then declare a bunch of devices on those busses. DT makes this
> extremely straightforward.
> 
> However, it is critical that the DT, kernel and FPGA are matched
> together - we always arrange things so that the DTB, kernel and FPGA
> config are bundled together and update atomically during firmware
> upgrade.

Agreed.

> Xilinx's Zynq is a great example of this kind of stuff, FWIW. IIRC

Indeed - Xilinx's Zynq, Altera's SoC FPGA, and others.

Such highly flexible hardware configurations require a new level of
software support that by far exceeds the classic static setups of more
"PC-like" systems where the only change you would expect is adding or
removing some PCI cards or the like.


Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Don't tell me how hard you work.  Tell me how much you get done.
                                                     -- James J. Ling