[PATCH 4/5] spi/mxs: Remove bogus setting of ssp clk rate field

[marex@denx.de (Marek Vasut)]

Dear Trent Piepho,

> On Mon, Apr 1, 2013 at 4:16 PM, Marek Vasut <marex@denx.de> wrote:
> >> The ssp struct has a clock rate field, to provide the actual value, in
> >> Hz, of the SSP output clock (the rate of SSP_SCK) after
> >> mxs_ssp_set_clk_rate() is called.  It should be read-only, except for
> >> mxs_ssp_set_clk_rate().
> >> 
> >> For some reason the spi-mxs driver decides to write to this field on
> >> init, and sets it to the value of the SSP input clock (clk_sspN, from
> >> the MXS clocking block) in kHz.  It shouldn't be setting the value, and
> >> certainly shouldn't be setting it with the wrong clock in the wrong
> >> units.
> > 
> > I suspect this patch should also fix drivers/clk/mxs/clk-ssp.c then?
> 
> Why do you say that?  I see no problem with clk-ssp.c, as setting the
> clk_rate field in the ssp struct to the actual programmed rate makes
> sense.  The code in spi-mxs.c just makes no sense.  I suspect it was
> added by mistake when porting the driver.

Either remove it altogether if it's unused OR make sure it's inited to some sane 
value from the start.

Best regards,
Marek Vasut