From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@free-electrons.com (Maxime Ripard) Date: Fri, 24 May 2013 22:10:30 +0200 Subject: [PATCHv3 1/6] net: Add EMAC ethernet driver found on Allwinner A10 SoC's In-Reply-To: <519F6128.9060608@elopez.com.ar> References: <1369387394-9453-1-git-send-email-maxime.ripard@free-electrons.com> <1369387394-9453-2-git-send-email-maxime.ripard@free-electrons.com> <519F6128.9060608@elopez.com.ar> Message-ID: <20130524201030.GA17847@lukather> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Emilio, On Fri, May 24, 2013 at 09:46:32AM -0300, Emilio L?pez wrote: > El 24/05/13 06:23, Maxime Ripard escribi?: > > From: Stefan Roese > > > > The Allwinner A10 has an ethernet controller that seem to be developped > > internally by them. > > > > The exact feature set of this controller is unknown, since there is no > > public documentation for this IP, and this driver is mostly the one > > published by Allwinner that has been heavily cleaned up. > > > > Signed-off-by: Stefan Roese > > Signed-off-by: Maxime Ripard > > --- > > (snip) > > > + > > +config SUN4I_EMAC > > + tristate "Allwinner A10 EMAC support" > > + depends on ARCH_SUNXI > > + depends on OF > > + select CRC32 > > + select NET_CORE > > + select MII > > + select REGULATOR_FIXED_VOLTAGE > > + ---help--- > > + Support for Allwinner A10 EMAC ethernet driver. > > + > > + To compile this driver as a module, choose M here. The module > > + will be called sun4i-emac. > > + > > You also need to select REGULATOR when you select REGULATOR_FIXED_VOLTAGE Actually, this should be in patch 2/6. Thanks for noticing! Maxime -- Maxime Ripard, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com