From mboxrd@z Thu Jan 1 00:00:00 1970 From: tony@atomide.com (Tony Lindgren) Date: Tue, 26 Nov 2013 13:55:37 -0800 Subject: [PATCH 1/2] ARM: dts: omap4-panda-common: Fix pin muxing for wl12xx In-Reply-To: <528E4295.2040109@ti.com> References: <1385041804-19115-1-git-send-email-balajitk@ti.com> <1385041804-19115-2-git-send-email-balajitk@ti.com> <20131121165823.GM10317@atomide.com> <528E4295.2040109@ti.com> Message-ID: <20131126215537.GO26766@atomide.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org * Dan Murphy [131121 09:28]: > On 11/21/2013 10:58 AM, Tony Lindgren wrote: > > * Balaji T K [131121 05:51]: > >> pin mux wl12xx_gpio and wl12xx_pins should be part of omap4_pmx_core > >> and not omap4_pmx_wkup. So, move wl12xx_* to omap4_pmx_core. > >> > >> Fix the following error message: > >> pinctrl-single 4a31e040.pinmux: mux offset out of range: 0x38 (0x38) > >> pinctrl-single 4a31e040.pinmux: could not add functions for pinmux_wl12xx_pins 56x > > Why is the led pins moved then? Heh the patch just looks that way, looking at the curly brackets thing do get moved properly. > >> SDIO card is not detected after moving pin mux to omap4_pmx_core since > >> sdmmc5_clk pull is disabled. Enable Pull up on sdmmc5_clk to detect SDIO card. > > Cool, does this fix the issue with the WLAN not coming up after a warm reset > > on panda? Also commit f446043f1aa7 (regulator: fixed: fix regulator_list_voltage() for regression) is needed that recently got merged. But with v3.13-rc1 + f446043f1aa7 + this patch no luck whatsoever bringing up the wl12xx so there must be also some regression somewhere from v3.12 on that? Regards, Tony