From mboxrd@z Thu Jan 1 00:00:00 1970 From: horms@verge.net.au (Simon Horman) Date: Thu, 26 Dec 2013 14:30:19 +0900 Subject: [PATCH] ARM: shmobile: koelsch: Conditionally select MICREL_PHY In-Reply-To: <52B37BAC.4090405@cogentembedded.com> References: <1387153872-8387-1-git-send-email-horms+renesas@verge.net.au> <52B37BAC.4090405@cogentembedded.com> Message-ID: <20131226053015.GA9638@verge.net.au> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Dec 20, 2013 at 02:05:16AM +0300, Sergei Shtylyov wrote: > Hello. > > On 12/16/2013 03:31 AM, Simon Horman wrote: > > >The koelsch board uses has an SH ethernet controller which uses a Micrel > >phy. Select MICREL_PHY for koelsch if SH_ETH is enabled to make use of the > >Micrel-specific phy driver rather than relying on the generic phy driver. > > >Signed-off-by: Simon Horman > >--- > > arch/arm/mach-shmobile/Kconfig | 3 +++ > > 1 file changed, 3 insertions(+) > > >diff --git a/arch/arm/mach-shmobile/Kconfig b/arch/arm/mach-shmobile/Kconfig > >index f01e878..670238a 100644 > >--- a/arch/arm/mach-shmobile/Kconfig > >+++ b/arch/arm/mach-shmobile/Kconfig > >@@ -41,6 +41,7 @@ config MACH_GENMAI > > config MACH_KOELSCH > > bool "Koelsch board" > > depends on ARCH_R8A7791 > >+ select MICREL_PHY if SH_ETH > > > > config MACH_KZM9D > > bool "KZM9D board" > > Simon, did you initially remove that hunk when committing? Thanks for noticing. I will queue up the following: From: Simon Horman ARM: shmobile: koelsch: Conditionally select MICREL_PHY for Multiplatform The koelsch board uses has an SH ethernet controller which uses a Micrel phy. Select MICREL_PHY for koelsch if SH_ETH is enabled to make use of the Micrel-specific phy driver rather than relying on the generic phy driver. Signed-off-by: Simon Horman --- arch/arm/mach-shmobile/Kconfig | 1 + 1 file changed, 1 insertion(+) diff --git a/arch/arm/mach-shmobile/Kconfig b/arch/arm/mach-shmobile/Kconfig index a127252..958ccf3d 100644 --- a/arch/arm/mach-shmobile/Kconfig +++ b/arch/arm/mach-shmobile/Kconfig @@ -45,6 +45,7 @@ config MACH_GENMAI config MACH_KOELSCH bool "Koelsch board" depends on ARCH_R8A7791 + select MICREL_PHY if SH_ETH config MACH_KZM9D bool "KZM9D board" -- 1.8.4