From mboxrd@z Thu Jan 1 00:00:00 1970 From: sergei.shtylyov@cogentembedded.com (Sergei Shtylyov) Date: Tue, 4 Feb 2014 18:55:32 +0300 Subject: [PATCH v2 2/2] ARM: shmobile: Koelsch: pass Ether PHY IRQ In-Reply-To: <201402041851.47198.sergei.shtylyov@cogentembedded.com> References: <201402041851.47198.sergei.shtylyov@cogentembedded.com> Message-ID: <201402041855.32618.sergei.shtylyov@cogentembedded.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Pass Ether's PHY IRQ (which is IRQC's IRQ0) to the 'sh_eth' driver. Set the IRQ trigger type to be low-level as per the Micrel PHY driver's setup. Signed-off-by: Sergei Shtylyov --- Changes in version 2: - refreshed the patch. arch/arm/mach-shmobile/board-koelsch.c | 4 ++++ 1 file changed, 4 insertions(+) Index: renesas/arch/arm/mach-shmobile/board-koelsch.c =================================================================== --- renesas.orig/arch/arm/mach-shmobile/board-koelsch.c +++ renesas/arch/arm/mach-shmobile/board-koelsch.c @@ -23,6 +23,7 @@ #include #include #include +#include #include #include #include @@ -92,6 +93,7 @@ static void __init koelsch_add_du_device /* Ether */ static const struct sh_eth_plat_data ether_pdata __initconst = { .phy = 0x1, + .phy_irq = irq_pin(0), .edmac_endian = EDMAC_LITTLE_ENDIAN, .phy_interface = PHY_INTERFACE_MODE_RMII, .ether_link_active_low = 1, @@ -232,6 +234,8 @@ static void __init koelsch_init(void) { koelsch_add_standard_devices(); + irq_set_irq_type(irq_pin(0), IRQ_TYPE_LEVEL_LOW); + if (IS_ENABLED(CONFIG_PHYLIB)) phy_register_fixup_for_id("r8a7791-ether-ff:01", koelsch_ksz8041_fixup);