From mboxrd@z Thu Jan 1 00:00:00 1970 From: thomas.petazzoni@free-electrons.com (Thomas Petazzoni) Date: Fri, 7 Feb 2014 09:25:05 +0100 Subject: [PATCH 03/21] ARM: Kirkwood: Convert mv88f6281gtw_ge switch setup to DT In-Reply-To: <1391730137-14814-4-git-send-email-andrew@lunn.ch> References: <1391730137-14814-1-git-send-email-andrew@lunn.ch> <1391730137-14814-4-git-send-email-andrew@lunn.ch> Message-ID: <20140207092505.4a0e9963@skate> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Dear Andrew Lunn, On Fri, 7 Feb 2014 00:41:59 +0100, Andrew Lunn wrote: > The mv88f6281gtw_ge has a ethernet switch connected to the ethernet > port of the SoC. Convert the platform device instantiationn to a DT > instantiation. > > Signed-off-by: Andrew Lunn > --- > arch/arm/mach-kirkwood/Kconfig | 7 ---- > arch/arm/mach-kirkwood/Makefile | 1 - > arch/arm/mach-kirkwood/Module.symvers | 0 > arch/arm/mach-kirkwood/board-dt.c | 3 -- > arch/arm/mach-kirkwood/board-mv88f6281gtw_ge.c | 50 -------------------------- > arch/arm/mach-kirkwood/common.h | 7 ---- > 6 files changed, 68 deletions(-) > create mode 100644 arch/arm/mach-kirkwood/Module.symvers This is probably a mistake. > delete mode 100644 arch/arm/mach-kirkwood/board-mv88f6281gtw_ge.c Hum, I maybe missed something, but where are the corresponding DT informations added to replace the C description of the Ethernet switch? Thanks! Thomas -- Thomas Petazzoni, CTO, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com