[PATCH RFC v1 3/3] ARM hibernation / suspend-to-disk

[sebastian.capella@linaro.org (Sebastian Capella)]

Quoting Sebastian Capella (2014-02-21 15:59:11)
> - Cyril Chemparathy as his email is bouncing back to me. 
> 
> Quoting Sebastian Capella (2014-02-21 10:39:56)
> > Quoting Lorenzo Pieralisi (2014-02-20 08:27:55)
> > > > > > +     cpu_switch_mm(idmap_pgd, &init_mm);
>   [ ... ]
> > I can try removing it and seeing if there are side effects.
> 
> FYI, It's definitely hanging with this removed, still looking.

I see when we reach this call, the 1st level page table @ TTBR0 is located
at different memory locations each run (expected).  If we omit the
cpu_switch_mm we're corrupting the page table causing the observed
intermittent failures.  I believe these match the corruption you expected.

The reason this doesn't happen when I leave the call is that idmap_pgd
is always at the same memory location.  I expect this is because it's
allocated during init.  I've seen the same address 50/50 times for
idmap_pgd.  I don't think it is correct to rely on this behavior.

Would it be appropriate to use the swapper_pg_dir directly in place
of idmap_pgd?
  - I do not see any modification to the swapper_pg_dir contents in the
    code that would change from init time.
  - swapper_pg_dir is always at the same offset.

Ideally we should have no issue with overwriting it with identical data.

I've run a couple hundred test loops using swapper_pg_dir and so far
there are no failures.

Thanks,

Sebastian